Radio Shack 61-2677C owner manual Setting the MODULE’S Codes

Page 12
HOUSE CODE

61-2677CD.fm Page 12 Tuesday, July 6, 1999 11:05 AM

Low-voltage electricity flows through the circuit con- trolled by a switch module, even when the switch is off. This is necessary for proper operation of the switch module. You can completely turn off the electricity by setting the switch’s disable switch to off (left).

Caution: Do not use a wall outlet module to replace an out- let that is controlled by a wall switch.

SETTING THE MODULE’S CODES

Seton all your modules to the same letter as HOUSE CODE on your controller (A through P).

When setting the UNIT CODE, make sure that all modules that are set to the same unit code respond as a group. If you have several modules controlling lights in a single room, set them to the same unit code. (If you set every light module to a different unit code, you might not have enough separate unit codes to complete your system.)

12

Image 12
Contents Mini Remote Control Center Introduction Contents Preparation House Codes On the controller and all the modules itUnit Codes Installation Setting UP the Control CenterSetting UP the Modules 61-2677CD.fm Page 8 Tuesday, July 6, 1999 1105 AM Command 61-2677CD.fm Page 10 Tuesday, July 6, 1999 1105 AM 61-2677CD.fm Page 11 Tuesday, July 6, 1999 1105 AM Setting the MODULE’S Codes Connecting Lights or Appliances to Modules Operation Controlling Modules by Unit CodesTurning on ALL Lights Turning OFF ALL Units Dimming Lights Manual Control of Lights and Appliances Power Interruptions Intercom InterferenceSafety Precautions 61-2677CD.fm Page 21 Tuesday, July 6, 1999 1105 AM Troubleshooting Problem Remedies61-2677CD.fm Page 23 Tuesday, July 6, 1999 1105 AM Plug ’N Power System Chart Care 61-2677CD.fm Page 26 Tuesday, July 6, 1999 1105 AM 61-2677CD.fm Page 27 Tuesday, July 6, 1999 1105 AM 07A99