Radio Shack 6 IN 1 RF REMOTE CONTROL SYSTEM Setting UP the System, Setting UP the Remote Control

15-1919.fm Page 7 Monday, July 19, 1999 12:34 PM

SETTING UP THE SYSTEM

INSTALLING BATTERIES IN THE REMOTE CONTROL

Your system’s remote control uses four AAA batteries (not supplied) for power. We recommend alkaline bat- teries, such as Radio Shack Cat. No. 23-555. Follow these steps to install the batteries.

1.Press the battery compartment cover tab and lift off the cover.

2.Install four fresh batteries, as indicated by the polarity symbols marked in the compartment.

3.Replace the cover.

Notes:

•Do not place objects on top of the remote control after you install the batteries. This can press down keys and reduce battery life.

•When the remote control’s range decreases or it operates erratically, replace the batteries.

•Be sure to have fresh batteries ready to install before you remove the old batteries. The remote control’s memory only lasts about a minute with- out the batteries. If the memory is lost, you must re-enter the 3-digit manufacturer’s codes for your remote-controlled devices.

SETTING UP THE REMOTE CONTROL

1.Refer to “Manufacturers’ Codes” and write down the codes for your remote-controlled devices on the provided label.

2.Press the device key for the remote control you are replacing (CD, VCR, CBL, TV, AUX1, or AUX 2).

SETUP		Lts On	PWR
		All
CD	VCR	CBL	TV
AUX 1	AUX 2	A/B	Plug'n
			Power
		3	On
			CH

Need help? Call 1-800-950-7044!

7