Radio Shack 6 IN 1 RF REMOTE CONTROL SYSTEM owner manual TV SET UP 0 5

15-1919.fm Page 8 Monday, July 19, 1999 12:34 PM

3.Press down and hold SET UP until the red indica- tor blinks twice, then release it and enter the 3- digit manufacturer’s code

.

3

SETUP			Lts On	PWR
			All
CD		VCR	CBL	TV
AUX	1	AUX 2	A/B	Plug'n
				Power

For example, to replace a Panasonic TV’s remote control (manufacturer’s code 051), press:

TV SET UP 0 5 1

When the indicator blinks twice again, you have correctly entered the code.

4.Point the system’s remote control at your device and press PWR. The device should turn on (or off, if it was on).

5.Repeat Steps 2–4 for additional devices.

If the remote does not operate your device, try other codes listed in “Manufacturers’ Codes” for your brand of TV, VCR, cable converter, or other devices.

If your device still does not respond, follow the steps outlined in “If You Have Problems.”

Note: The punch-through feature is automatically turned on for the TV’s volume and mute controls. This means that when you select cable (CBL) and press one of the volume buttons or the mute button, the remote actually sends the codes to the television and not the cable converter. If you want to use your cable convert- er’s volume and mute controls, disable the punch- through feature for these buttons. See “Punch- Through.”

Need help? Call 1-800-950-7044!

8