Programming Macros

Your remote has four macro keys (MUSIC, MOVIES, SPORTS, and NEWS) that store up to three channels per macro key for instant tuning of TV or cable/satellite channels. For example, if your favorite sports channel on your cable service is 061, you can store it as an in- stant tune-in macro.

Follow these steps to program macros.

1.Hold down P until the red light blinks twice.

2.Press 9 9 5. The red light blinks twice.

3.Press the desired macro key (MUSIC, MOVIES,

SPORTS, or NEWS).

4.Press CBL/SAT or TV to select a device.

5.Press the numbers for the desired channel (0 6 1 for the sports channel in the previous example).

6.Hold down P until the red light blinks twice.

Note: If your original remote control requires you to press Enter or Select to send a command, press Enter or Select after entering your channel number. Then, hold down P until the red light blinks twice.

If you want to add two more channels to the macro keys, repeat Steps 1–6 twice, each time substituting another channel number in step 5.

Note: You can only program three channels for each macro key. Programming more than three channels will overwrite one or more of your original channel set- tings.

PROGRAMMING THE POWER KEY

Your remote can store a power on/off sequence to control the power of up to six devices with a single key press. Once the desired sequence is stored, POWER acts as a master power key when held down for at least 2 seconds.

12Preparation