Perle Systems C-10GT-XFPH, CM-10GT-SFP manual Compliance Information, Contacting Technical Support

Page 16

Compliance Information

FCC

This product has been found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions in this Guide, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his/her own expense.

EN 55022 Class A

WARNING This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

EN 55024 Class A

Contacting Technical Support

Contact information for the Perle Technical Assistance Center (PTAC) can be found at the link below. A Technical Support Query may be made via this web page.

www.perle.com/support_services/support_request.shtml

Warranty / Registration

Perle’s standard Lifetime Warranty provides customers with return to factory repairs for Perle products that fail under the conditions of the warranty coverage. Details can be found at:

http://www.perle.com/support_services/warranty.shtml

Copyright © 2013 Perle Systems Limited

All rights reserved. No part of this document may be reproduced or used in any form without written permission from Perle Systems Limited.

Perle C/CM-10GT Media Modules Installation Guide

16

Image 16
Contents Perle 10GT Media Converter Modules Installation Guide Overview Model Port TypeGetting to know your C/CM-10GT Media Converter Front ViewCM-10GT-SFP or C/CM-10GT-XFPH Link Mode Switch 2 Data Mode Operating Mode SwitchSwitch Position Mode Switch Position Type Test Function Switch 2 Test ModeIllustration of the Built In Link Test Fiber Fault Alert Switch 3 Data Mode Sequence of EventsPort Selection Switch 3 Test Mode Fiber Fault Alert Sample ConfigSwitch Position Port Installing Modules EEE Energy Efficient EthernetAUTO-Config Jumper CM models only PWR Power/Test Red blinking slowly while in Test mode indicates an errorOperation Status LEDLK1- Port 1 Activity LK1 LK2 Error CodesLK2 Port 2 Activity General TroubleshootingNo connectivity Module Temperature Protection Loopback TestTechnical Specifications SFP+ and Xfph Feature SetFiber Cabling Requirements Copper Cable RequirementsCompliance Information Warranty / RegistrationContacting Technical Support