Perle Systems C-10GT-XFPH Fiber Fault Alert Sample Config, Port Selection Switch 3 Test Mode

Page 8

Fiber Fault Alert Sample Config

Media Converter Module A Configuration

Link Mode–Standard Mode

Fiber Fault Alert

Media Converter Module B Configuration

Link Mode–Smart Link Pass through Mode

Fiber Fault Alert

Sequence of Events

1.Media Converter Module A loses fiber connection (RX).

2.Media Converter Module A notifies the remote Media Converter Module that there is a fault on the Link.

3.Media Converter Module B detects loss of fiber link on receiver (RX).

4.Media Converter Module B turns off transmitter (TX).

Port Selection (Switch 3 – Test Mode)

Switch Position	Port

Up (default)	1

Down	2

When Loopback mode is selected (Switch 1 and Switch 2 down), this switch specifies which port to enable loopback mode on.

Perle C/CM-10GT Media Modules Installation Guide

8

Image 8

Contents Perle 10GT Media Converter Modules Installation Guide Overview Model Port TypeGetting to know your C/CM-10GT Media Converter Front ViewCM-10GT-SFP or C/CM-10GT-XFPH Switch Position Mode Operating Mode SwitchLink Mode Switch 2 Data Mode Illustration of the Built In Link Test Test Function Switch 2 Test ModeSwitch Position Type Fiber Fault Alert Switch 3 Data Mode Sequence of EventsSwitch Position Port Fiber Fault Alert Sample ConfigPort Selection Switch 3 Test Mode Installing Modules EEE Energy Efficient EthernetAUTO-Config Jumper CM models only PWR Power/Test Red blinking slowly while in Test mode indicates an errorOperation Status LEDLK2 Port 2 Activity LK1 LK2 Error CodesLK1- Port 1 Activity No connectivity TroubleshootingGeneral Module Temperature Protection Loopback TestTechnical Specifications SFP+ and Xfph Feature SetFiber Cabling Requirements Copper Cable RequirementsContacting Technical Support Warranty / RegistrationCompliance Information