Perle Systems C-10GT-XFPH, C-10GT-SFP manual CM-10GT-SFP or C/CM-10GT-XFPH

Installation

The default switch setting (all switches in the UP position) will work for most installations. The Auto-Jumper is set to Auto for Ethernet Auto detection.

These are the steps required to configure the Perle C/CM-10GT module.

1.Set the Auto-Jumper switch. (optional)

2.Set the DIP switch settings. (optional)

3.Install the module into the chassis. See Installing Modules.

4.Insert the appropriate SFP+/XFP into the transceiver port.

5.Connect the fiber cable.

6.Connect the RJ-45 (copper cable). See Copper Cable

Requirements.

C/CM-10GT-SFP or C/CM-10GT-XFPH

Perle C/CM-10GT Media Modules Installation Guide 4