EEE (Energy Efficient Ethernet)
Switch Position | Mode |
|
|
Up (default) | Enabled |
|
|
Down | Disabled |
|
|
Enabled: When enabled, the media converter will auto negotiate this capability with the attached EEE compliant devices/servers.
Disabled: The media converter will not auto negotiate this capability with the attached EEE compliant devices/servers.
Installing Modules
1.Set any jumpers and/or DIP switches on the module to the desired operating mode.
2.Gently slide the module into the slot until it becomes flush with the front of the chassis. Light pressure may be needed to seat the module. Do not force the module as you might damage the module. If there is resistance, remove the module and check the module’s backplane connector for damage to the pins. If the module’s backplane connector is not damaged, try to reinsert the module again.
3.Tighten the Captive retainer screw to ensure the module is locked in place.
Caution: Observe electrostatic discharge precautions when installing or removing the module(s) from the Chassis. Failure to observe this caution could result in damage to the module(s) and/or chassis.
Perle | 9 |