Memorex URC 4880 manual Using the Menu KEY, Using Keymover, Changing Volume Lock

Page 15

CHANGING VOLUME LOCK (Continued)

To change Volume Lock back to the TV mode:

1. On the remote control, press and hold SET until the LED blinks twice, then release SET.

2. Enter 9 - 9 - 3 and then press TV once. The LED will blink twice.

3.Now, whenever you press VOL +, VOL , or MUTE on the remote control, volume will be again controlled by your TV.

USING THE MENU KEY

On your One For All 4-Device Video Expert Plus With Learning remote control, the MENU key works just like the MENU key of your original remote control and allows you to access the on-screen menu of the component you have selected (e.g., TV, VCR, DVD, or CBL/SAT).

When you press MENU, the VOL+, VOL–, CH+, and CH – keys will allow you to navigate and adjust the on screen menu settings just like you would with your original remote control. Also, the MUTE key becomes the Menu Select key.

To exit out of the Menu mode, press or EXIT to return to normal operation.

USING KEYMOVER

The One For All 4-Device Video Expert Plus With Learning remote control includes a Keymover feature that allows you to map (or copy) keys from one mode (i.e., source mode)to another (i,e, destination mode).

NOTE: The following keys cannot be mapped: TV, DVD, VCR, CBL/SAT, SET, M.POWER, V.CONFIG, and learning keys L1~ L4.

For example, if your VCR does not have volume control, you can map the volume and mute keys from the TV mode to the VCR mode as follows:

1. On the remote control, press and hold SET until the LED blinks twice, then release SET.

2. Enter 9 - 9 - 4.

3. For the source mode, press TV once.

4. For the source key, press VOL + once.

5. For the destination mode, press VCR once.

6. For the destination key, press VOL + once.

7. The LED will blink twice indicating the key- moved sequence is correct.

8. Repeat steps 1 through 7 twice more, substitut- ing VOL – and MUTE as source and destination keys in steps 4 and 6.

Upon completion of the above procedure, you can now use your One For All 4-Device Video Expert Plus With Learning remote control to control the TV’s volume and mute in the VCR mode, as well as in the TV mode.

28

29

Image 15
Contents URC 4880 Video Expert Plus With Learning Introduction Table of ContentsFeatures and Functions Installing Batteries Key ChartsIf available Write your TV code in the boxes below for future reference Setup Codes for TVsProgramming TV Control TV BrandMGA KECKTV LXIWrite your VCR code in the boxes below for future reference Setup Codes for VCRsProgramming VCR Control VCR BrandSTS Programming TV/VCR Combo Control Setup Codes for TV/VCR CombosNSC Setup Codes for Cable ConvertersCable Converter Brand Satellite Receiver Brand ABCHTS Setup Codes for Satellite ReceiversProgramming DVD Player Control DVD or LD BrandEnter 9 9 1. The LED will blink twice Setup Codes for DVD PlayersSetup Codes for LD Players Searching for Your CodeThen release SET Checking the CodesEnter 9 9 0. The LED will blink twice Press CBL/SAT onceTo change Volume Lock to the DVD mode Changing Volume LockTo change Volume Lock to the CBL/SAT mode To change Volume Lock to the VCR modeUsing the Menu KEY Using KeymoverChanging Volume Lock Using Learning Keys Programming The L KeysDeleting Functions From The L Keys An Example Video Configuration StepLED will blink twice An Example Video Configuration TroubleshootingPart No. URC4880 Additional Information