Memorex MVR2040-A owner manual Battery Installation, Battery Cautions, Feet

Page 13

BATTERY INSTALLATION

1	Open the battery compart-
	ment cover.

BATTERY CAUTIONS

2

Install two "AAA" (penlight size) batteries.

3

Replace the cover.

ENGLISH

Follow these precautions when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer's directions.)

EFFECTIVE DISTANCE OF THE REMOTE CONTROL

30°

30°		15 FEET
30°

NOTES: • When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the Remote Sensor, the remote operation may be unstable.

•When there is an obstacle between the VCR and the remote control, the remote control may not operate.

13

4C80401A-E(P10-19)

13

25/2/99, 21:24

Image 13

Contents MVR2040A English Accessories CleaningPower Sources Read InstructionsPower Lines POWER-CORD ProtectionDamage Requiring Service Replacement PartsWall or Ceiling Mounting Safety CheckHeat Features Table of Contents When YOU Experience the Above Conditions PrecautionsMoisture Condensation Moisture will Condense on the Unit in the Following CasesAvoid extreme moisture and dust Front Location of ControlsDescription of Controls AC Power Cord Connect to a 120V 60Hz outlet Location of Connectors RearFluorescent Display Tape SpeedDescription of Buttons Remote ControlBattery Cautions Battery InstallationEffective Distance of the Remote Control FeetAntenna to VCR Connection Basic ConnectionsEnglish VCR to TV Connection Splitter OHM Input 75/300 OHM Outputs VCR Incoming Cable Catv Cable TV ConnectionsAllows For basic cable service, no premium scrambled channelsVCR Splitter Recording scrambled channels AUDIO/VIDEO Connection AUDIO/VIDEO ConnectionsStereo Amplifier Connections Switch Rear of the VCR to Setting the Video ChannelFor a push-button TV tuner Check Before YOU Begin ON-SCREEN Language SelectionTo make any adjustments perform steps 2 through Setting the ClockTo select the Clock SET Option, then pressUP option, then press the Enter button Setting the ChannelsCH Memory mode, then press the Enter Automatic Memory TuningButton To ADD/DELETE Channels Using the SET + or buttonMode, then press Channel from memoryNoise Elimination Blue Screen Turn on the VCR Power buttonPress the TV/VCR selector button to select Loading Loading and Unloading Video Cassette TapesUnloading To Start Playback Tapes PlaybackTo Stop Playback To play a prerecorded cassette tapeTo Rewind or Forward the Tape Rapidly PlaybackFORWARD/REVERSE Picture Search To Visually Search for Desired Points Special PlaybackSkip Search To Watch a Still PictureTo Watch a Tape Repeatedly Over and over until the repeat mode is canceledRepeat option PositionRecording and Viewing the Same TV Program Recording a TV ProgramTab intact VCR will automatically turn onTo Stop Recording Temporarily To Stop RecordingPress the REC/OTR button Press the Stop button to stop recordingWill continue While the VCR is recording, press the TV/VCR3 hours HoursMenu Enter Setting the Timer RecordingCH 125 or To Correct the Settings