Marantz DV7600 manual Setup Examples, Hdmi Audio Output

Page 38

6DVD Setup Menu

Setup Examples

	Resolution		Playback Disc

		Disc Recorded in Squeeze Ratio		Disc Recorded in 4:3 Ratio
	(HDMI Setting)	Disc Recorded in Squeeze Ratio		Disc Recorded in 4:3 Ratio

		Aspect (HDMI Setting)	Monitor Settings	Aspect (HDMI Setting)	Monitor Settings

	480p/576p		Full/Squeeze	4:3	Standard
	(525p/625p)	16:9 Wide	Full/Squeeze	16:9 Wide	Standard
	(525p/625p)	16:9 Wide		16:9 Wide	Normal
					Normal
	720p/1080i	16:9 Squeeze	Normal/Through	16:9 Squeeze	4:3
	720p/1080i	16:9 Squeeze
	(750p/1125i)				Through
					Through

Some monitors may use setting names that are different than those shown here.

Audio

•Auto: Audio is output as a bit stream when the connected device is set to Dolby Digital, DTS, or MPEG. Audio is output as linear PCM when the connected device is set to Linear PCM. If the connected device cannot accept bit streams, audio will be output as linear PCM.

•PCM: Audio is converted to linear PCM.

•OFF: HDMI output Audio = OFF

Select the Digital Out (page 12) setting as described in “Setup Menu - Audio” (page 39).

Select one of the above with the ENTER button.

HDMI Audio Output

Note

•Audio is not output from Super Audio CDs or DVD-Audio discs with CPPM protection.

•Audio is not output when the player is con- nected to a device with an HDCP-compatible DVI jack.

•All of PCM signal from digital out (page 12) is converted to 44.1kHz/48kHz.

•Turn the power on the front panel OFF during play or pause. Noise from a television etc. may come out.

•When HDMI Audio is set to Auto or PCM, the Digital Out (page 12) setting is as per HDMI Audio.

					HDMI Setting (Audio)
		Audio Formats
			Auto		PCM	OFF

	Dolby Digital		Dolby Digital*1		2 Channel DOWNMIX	OFF

DVD	Linear PCM		Left/Right		Left/Right	OFF

	DTS		DTS*1		2 Channel DOWNMIX	OFF
	DTS		DTS*1		2 Channel DOWNMIX	OFF

	MPEG		MPEG*1		Left/Right	OFF
		With CPPM protection	*2		*2	OFF
DVD-Audio
DVD-Audio		Without CPPM protection	*2		*2	OFF
		Without CPPM protection	*2		*2	OFF

CD/MP3/Super Audio CD*3				Left/Right		OFF

DTS CD			DTS*1		2 Channel DOWNMIX	OFF

Video CD				Left/Right		OFF

*1: The player automatically switches to PCM output when the connected device does not support Dolby Digital, DTS, or MPEG bit streams.

*2: Output will be 48kHz/16-bit or 44.1kHz/16-bit.

Multi-channel PCM sources are down mixed to channel 2. (A source whose down-mixing is prohibited is only output to FL/FR.)

*3: Audio is not output from Super Audio CDs. This applies to only play the CD Audio part.

38

Image 38

Contents Model DV7600 User Guide Laser Safety Important Safety Instructions CE marking for Europe only Table Of Contents Features Before You StartWhat’s in the box Putting the batteries in the remote controlUsing the remote control Close the coverDiscs compatible with this player DVD-Video regions MP3 compatibility informationConnecting audio/video cables Connecting UpEasy setup Connecting system control cablesHome theater video connections Connecting Hdmi cablesTo the A/V Euro Connector on Video or composite video?Connecting coaxial cables Connecting analog audio cablesConnecting optical cables Home theater audio connectionsControls & Displays Front panelCharacter display Prog Lights when replaying a programDisplay Depending on the disc, the Down MIX is not displayedOutput off and on Remote controlVideo ON/OFF press to turn video +10 button is not used on this setPlaying discs Getting StartedBasic playback controls Some discs don’t allow PBC menus Navigating DVD disc menusNavigating Video CD PBC menus Introduction Press the Search button during playback modePlaying Discs Finding what you want on a discPress 3PLAY button or the Enter button. Note Stop mode of DVDExample Viewing slow playback Viewing a Pausing PictureStill Frame/Slow Play/Frame Advance Playback Step Motion playback Viewing one frame at a timePress Random button during playback UsingUsing the Random Play TipLooping a section of a disc Using the Repeat PlayPress Repeat during playback to select a repeat mode To resume normal playback, press A-B again. NoteSwitching Subtitle Language Switching Super Audio CD ModeSwitching Camera Angles To switch the camera angle, press ANGLE. NoteSwitching audio channel Switching Audio LanguageUsing the Zoom Function To switch the audio channel, press Audio repeatedlyDisplay on the front panel change as follows Only Single Elapsed time is displayedMaking a program list Playing MP3s Using Random PlayUsing Repeat Play Playing Jpeg Video AdjustSelecting a preset Play button or Enter buttonPress Enter to save your changes. Note Creating your own settingUse the cursor buttons 2/3 to select a DVD Setup Menu Using the FL menuUsing the Setup Menu Mode or Stop modeHdmi VideoSpeaker* SP LevelSetting up the Video Setup TV AspectWhen viewing on a widescreen TV or monitor Angle Mark Slide show ModeTV System Compatibility of this unit with progressive-scan TVs Default setting VideoComponents Out Format Setting up the Hdmi SetupResolution Hdmi Audio Output Setup ExamplesAudio Select one of the above with the Enter buttonDigital Out Setting up the Audio SetupDefault setting PCM Mpeg OutPCM Down Sample Default setting OnPCM Down Sample SRS TruSurround Default setting 2 Channel StereoAudio Out About source audio output Default setting OffAudio DRC RememberSize Setting up the Speaker SetupDefault setting 10 ft/3.0 m DistanceLanguage settings Setting up the SP Level SetupSetting up the Disc Setup DVD Audio Player ModeDefault setting DVD Audio DVD VideoSetting up the System Setup Resetting the Player Additional Information Moving the player Hints on installationPower cord caution Don’tGlossary Optical digital output Mpeg videoMulti-session Packed PCM DVD-Audio onlyTroubleshooting No audio, or audio is distorted Remote control doesnt seem to workPicture disturbance during playback or dark Cannot output 192kHz or 176.4kHz digital audio Cannot play multi-channel audioNo digital audio output Cannot output 96kHz or 88.2kHz digital audioSpecifications GeneralIs a registered trademark