Part Names and Functions, Front Panel, Rear Panel

ENGLISH

Introduction

Part Names and Functions

Front Panel

Introduction

Rear Panel

10 11

						14
1	2	3	4 5	6	7	16 15

The unit can also be turned on by pressing the buttons with circled numbers.

1	6	9

1.STANDBY indicator

This indicator lights up in green when the power is on, and lights up in red in standby mode.

2.ON/STANDBY button

Press to turn the unit to standby mode. In standby mode, this unit still consumes small amount of power.

3.ON / OFF (POWER) switch

Press to turn the unit on and off. If you turn off the unit using this switch, the unit does not consume power. In this condition, this unit does not accept any button except this switch.

4.VIDEO NR indicator

Indicates that video signals of a BD, DVD, etc., are being processed digitally with the DNR (Digital Noise Reduction) processing.

5.Infrared sensor window

Receives signals from your remote control so that you can control the unit from a distance.

6.Display

Refer to “Front Panel Display” on page 9.

7.SD CARD slot

Insert an SD Memory Card, and play back the contents in it.

8.Disc tray

Place a disc when opening the disc tray.

9.A OPEN/CLOSE button

Press to open or close the disc tray.

10.B PLAY button

Press to start or resume playback.

11.C STOP button

Press to stop playback.

12.H / G (SKIP DOWN/UP) button

Press to skip down/up titles/chapters/tracks/files.

13.h / g (FAST FORWARD/REVERSE) button

Press to search forward / backward through a disc.

14.F PAUSE button

Press to pause playback.

15.VIDEO NR (NOISE REDUCTION) button

Press repeatedly to reduce the overall level of noise on the picture (DNR). Each time you press the button, the level of the DNR switches “Off” A“+1” A“+2” A“+3” A“Off”.

16.HDMI (RESOLUTION) button

Press to set the HDMI jack’s video signal output mode.

1.DIGITAL OUT jack

Use digital audio coaxial/optical cable to connect to an AV receiver, Dolby Digital decoder or other device with a digital audio coaxial/optical input jack.

2.7.1ch AUDIO OUT jacks

Use an RCA audio cable to connect these jacks to the 7.1-channel audio input jacks of your amplifier with 7.1-channel input terminals.

3.2ch AUDIO OUT jacks

Use an RCA audio cable to connect these jacks to the 2-channel audio input jacks of your amplifier with 2- channel input terminals.

4.VIDEO OUT jack

Use an RCA video cable to connect to a TV monitor, AV receiver or other device.

5.S VIDEO OUT jack

Use an S-video cable to connect to the S-video input jack of external device.

6.HDMI OUT jack

Use an HDMI cable to connect to a display with an HDMI input jack.

7.COMPONENT VIDEO OUT jacks

Use a component video cable to connect to a display device with component input jacks.

8.REMOTE CONTROL OUT/ IN jacks

By connecting this Blu-ray player to another Marantz component, you can remotely operate the components as a single system. For connections, use the control adaptor cable. (Mini Jack to RCA)

9.CONTROL CONNECTOR (RS-232C)

This is a terminal for future system extension.

10.AC IN Terminal

Use to connect the AC cord to supply the power.

Note

•Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the unit.

ENGLISH