Marantz BD8002 Speaker Setting, Menu Setting items Options Descriptions, Speaker Configuration

ENGLISH

Function Setup

Speaker Setting

This unit allows you to enjoy multi-channel surround sound such as 7.1-channel / 5.1-channel surround.

<Example of basic layout with 7.1ch surround system>

Front speaker (left) Front speaker (right)

Center speaker

Subwoofer

Surround speaker (left) Surround speaker (right)

Surround back speaker (left) Surround back speaker (right)

To make the most of its feature, set up your speakers appropriately by referring to the table below. Speaker setting options are available at the following locations;

<Speaker setting for the audio signal output from the HDMI OUT jack > (Available when you have HDMI cable connected to the HDMI OUT jack) Setup AQuick A HDMI Audio Out A HDMI Multi(LPCM)

Setup ACustom A Audio A HDMI Audio Out A HDMI Multi(LPCM)

<Speaker setting for the audio signal output from the 7.1ch AUDIO OUT jacks > Setup AQuick A 7.1ch Audio Out A Multi Channel

Setup ACustom A Audio A 7.1ch Audio Out A Multi Channel

Function Setup

How to navigate through the “HDMI Multi(LPCM)” and “Multi Channel” setting

1)Use [U / V] to select the menu item.

2)Use [U / V] to select setting items.

•Use [RETURN] to go back to the previous screen.

3)Use [Y / Z] to select desired options.(Except for “Test Tone” and “Default”.)

For “Test Tone”:

Use [Y / Z] to select “Manual” or “Auto”, then press [ENTER].

•The test tone will be output. If you select “Manual”, use [U / V] to select desired speaker, then use [Y / Z] to adjust the volume. If you select “Auto”, use [Y / Z] to adjust the volume of the speaker that output the test tone.

•If you want to stop the test tone, press [RETURN].

For “Default”:

Press [ENTER] to reset the “Delay Time” setting to the default.

4)Press [SETUP] to exit.

Menu	Setting items	Options	Descriptions
Speaker Configuration	Front	Large*	Large:
Select the desired			For the large speakers
		Small
speaker to set. Then			with strong low frequency
	Center	Large*
change the setting			reproduction capabilities.
appropriately by		Small/None	Small:
referring to the			For the small speakers
	Subwoofer	On*
descriptions.			which do not provide
		Off
			strong bass sound.
	Surround	Large*	None:
			No speakers.
		Small/None
			For “Subwoofer” there is
	Surround Back	Large*
			only “On” or “Off”.
		Small/None
	Crossover Freq:	40/60/80*/	Select according to the
	For speakers set to	100/120Hz	low frequency
	“Small”, the sound		reproduction capabilities
	with frequencies		of the connected speaker.
	below that of this
	frequency are cut.
	This bass sound that
	has been cut is
	output from the
	subwoofer or a
	speaker for which
	“Large” is set.

•For “Speaker Configuration”, the settings of each speaker sizes may be adjusted automatically corresponding to each setting. (e.g. If the “Front” is set to “Small”, the “Subwoofer” will automatically set to “On” and also you cannot set “Center”, “Surround”, and “Surround Back”, to “Large”.)

•If you connect to 5.1-channel surround system, set “Surround Back” in “Speaker Configuration” to “None”.

•“None” for “Center”, “Surround” and “Surround Back” is not available for the speaker setting for the audio signal output from the HDMI OUT jack .

•“Off” for “Subwoofer” is not available for the speaker setting for the audio signal output from the HDMI OUT jack.

34

ENGLISH