Home theater video connections, Pages 38 | Marantz Dv4003 instruction

•

ENGLISH

Connecting Up

Home theater video connections

This player outputs video in a number of different ways. Choose the one most suitable for your system using the guide below.

Important

•Before making or changing any rear panel connections, make sure that all components are switched off and unplugged from the wall outlet.

•While a connected component is turned on, do not unplug the power cord of this DVD player from the wall outlet. The speaker may be damaged.

Up Before You Start

If your TV has a component video input, we	If your TV has a SCART input, we
1 recommend using it to connect directly to the	recommend using it to connect directly
COMPONENT VIDEO OUT of this player. Use	to the A/V EURO CONNECTOR on
the standard 3-jack component video output.	this player. (for Europe only)

	AUDIO CR/PR	VIDEO	REMOTE
	Y	VIDEO	CONTROL
	L	IN	CONTROL
	L
			INT. EXT.
	R	OUT
	R	S1
HDMI	DIGITAL CB/PB	A/V EUROCONNECTOR	AC IN
HDMI	ANALOG COAX. COMPONENT	A/V EUROCONNECTOR	AC IN

Control & Displays Connecting

3 If your TV and projector have	2 If a component input is not	4 Plug into a standard
a HDMI terminal for Video and	available to you, connect this	AC wall outlet.
Audio Input, we recommend	player to your TV or AV receiver
using it to connect directly to	using either the VIDEO or S1
the HDMI out of this player.	jacks.

Getting Started

Connecting SCART (for Europe only) and S-Video cables

SCART and S-Video cables will only plug in one way, so make sure the plug is correctly lined up with the jack before inserting. Be sure to fully insert for a good connection.

Note

•The A/V EURO CONNECTOR can output composite or RGB component video. If you connect just one TV, use the A/V EURO CONNECTOR. You can select the type of video output by changing the COMPONENT setting in the DVD Setup Menu (page 41).

S-Video or composite video?

S-Video should give a better picture, so if you have an S-Video input, use it. S-Video cables are available from any good audio/ visual dealer.

Connecting HDMI cables

With an HDMI cable, both uncompressed video data and digital audio data (e.g., LPCM or bit stream data such as Dolby Digital, DTS, or MPEG data) can be transmitted with just a single connector.

By transmitting DVD image data directly as digital data without it being ﬁrst converted into analog format, it becomes possible to provide the very ﬁnest in image quality (see

pages 38, 42-43).

Note

•The HDMI output of this unit can be connected to a DVI jack on a TV or other device using a conversion adapter. In this case, it is necessary to use a TV or display with an HDCP-compatible DVI input.

•There may be no image output if connected to a TV or display that is not compatible with the above format.

•Refer to the instruction manual of the TV or display to be connected to this unit for detailed information regarding the HDMI terminal.

•When connecting a progressive input TV with the component output of the player, select ON in the Progressive setting (see page 40).

Additional DVD Setup Menu Playing Discs Information