Wall or Ceiling Mounting

IMPORTANT SAFETY INSTRUCTIONS (CONTINUED)

15.

OVERLOADING

16.

Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

OBJECT AND LIQUID ENTRY

Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could

result in fire or electric shock. Never spill or spray

any type of liquid on the product.

17.

OUTDOOR ANTENNA GROUNDING

If an outside antenna is connected to the

product, be sure the antenna system is

grounded so as to provide some protection

against voltage surges and built-up static

charges. Section 810 of the National Electric

Code, ANSI/NFPA 70, provides information with

respect to proper grounding of the mast and

supporting structure, grounding of the lead-in

wire to an antenna discharge product, size of

grounding conductors, location of antenna

discharge product, connection to grounding

electrodes and requirements for grounding

18.

electrodes.

SERVICING

EXAMPLE OF ANTENNA GROUNDING AS PER

Do not attempt to service this product yourself as

opening or removing covers may expose you to

NATIONAL ELECTRICAL CODE

19.

dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that

20.

have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

SAFETY CHECK

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the

21.

product is in proper operating condition.

22.

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

DAMAGE REQUIRING SERVICE

Unplug the product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a. When the power-supply cord or plug is damaged.

b. If liquid has been spilled or objects have fallen into the product.

c. If the product has been exposed to rain or water.

d. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered

by the operating instructions, as an adjustment of other controls may result in damage and will often require extensive work by a qualified

technician to restore the product to its normal operation.

e. If the product has been dropped or the cabinet has been damaged.

23.

f. When the product exhibits a distinct change in performance–this indicates a need for service.

HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including

24.

amplifiers) that produce heat.

NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper

grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.