FUNAI LC200EM8G 5TV Screen Display Mode, 5Sleep Timer, Letterbox, Zoom, To Cancel the Sleep Timer

Page 16

WATCHING TV

5TV Screen Display Mode

DTV

2 types of display modes can be selected in the digital mode when the broadcasting station is sending 16:9 video signal.

Press [SCREEN MODE ] repeatedly to switch the TV aspect ratio.

5Sleep Timer

The sleep timer can be set to automatically turn off the unit after an incremental period of time.

1Press [SLEEP ] to set the sleep timer.

SLEEP OFF

LETTERBOXZOOM

[LETTERBOX]

Display the digital-supported program in full-screen. Black borders will spread in the upper and lower screen.

[ZOOM]

Enlarge and display the center area of the digital- supported program.

The right and left side of image will be cut off.

Note:

You may not switch the display mode depending on the program.

• Sleep timer display appears on the TV screen.

2Press [SLEEP ] repeatedly to change the amount of time until shut off.

SLEEP 120MIN.

You can set your unit to turn off after a set period of time (from 30 to 120 minutes).

Each press of [SLEEP ] will increase the time by 30 minutes.

After set up, the sleep timer display can be called up for checking by pressing [SLEEP ].

To Cancel the Sleep Timer

Press [SLEEP ] repeatedly until “SLEEP OFF“ is displayed on the TV screen.

Note:

The sleep timer setting display will automatically disappear in a few seconds.

When you disconnect the unit from the AC outlet or when a power failure occurs, the sleep timer setting will be canceled.

16

EN

Image 16
Contents To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect Antenna LC200EM8GIntroduction Important note is located on the rear of the cabinetPrecautions RADIO-TV Interference5Supplied Accessories 5Symbols Used in this Manual5Tilt Stand LocationFeatures Contents5Remote Control Function 5Installing the Batteries5Control Panel 5Rear PanelConnection 5Basic ConnectionAntenna Cable Connection Connection to Cable Box or Satellite BoxComponent Video Cable Connection 5External Device ConnectionVideo Cable Connection RCA video cable Video Connection5Initial Setup Initial Setting5Main Menu 5Auto Channel Scan 5Language SelectionWhat is the minor channel? Watching TV5Channel Selection Use CH. K/L or the Number buttons5Switching Each Mode 5Switching Audio ModeMain SAP5Screen Information Press DisplayBroadcasting Information Program Guide5TV Screen Display Mode 5Sleep TimerTo Cancel the Sleep Timer LetterboxOptional Setting 5Channel Add/Delete5Picture Adjustment 5Closed CaptionBrightness Contrast Tint SharpnessTo select Caption SERVICE, then Press Enter repeatedly to change the settingTo select DTVCC, then press Enter5DTVCC Style 5Back Light Setting 5Color TemperatureYou can set the desired brightness mode You can adjust color temperature of the TV screen5V-chip Certain programming inappropriate for childrenChange the setting To Set the Sub RatingsAssociation of America To select Mpaa RATING, then pressChange Password Enter password again in Confirm Password spaceTroubleshooting 5Troubleshooting GuideMaintenance Control’s infrared signalWith an AM radio Phone camerasInformation Limited Warranty