FUNAI LC200EM8G owner manual Precautions, RADIO-TV Interference

Page 3

17.OBJECT AND LIQUID ENTRY - Never push objects of any kind into this TV through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the TV.

18.SERVICING - Do not attempt to service this TV yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

19.DAMAGE REQUIRING SERVICE - Unplug this TV from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power supply cord or plug is damaged or frayed.

b.If liquid has been spilled, or objects have fallen into the TV.

c.If the TV has been exposed to rain or water.

d.If the TV does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the TV to its normal operation.

e.If the TV has been dropped or damaged in any way.

f.When the TV exhibits a distinct change in performance, this indicates a need for service.

20.REPLACEMENT PARTS - When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, injury to persons or other hazards.

21.SAFETY CHECK - Upon completion of any service or repairs to this TV, ask the service technician to perform routine safety checks to determine that the TV is in proper operating condition.

22.HEAT - This TV product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

INTRODUCTION CONNECTION INITIAL SETTING

5Precautions

LAMP IN LCD CONTAINS MERCURY, DISPOSE ACCORDING TO LOCAL, STATE OR FEDERAL LAW.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Note to CATV system installer:

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building as close to the point of cable entry as practical.

WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION

Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.

3

EN

Image 3
Contents LC200EM8G To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect AntennaImportant note is located on the rear of the cabinet IntroductionRADIO-TV Interference PrecautionsLocation 5Supplied Accessories5Symbols Used in this Manual 5Tilt StandContents Features5Installing the Batteries 5Remote Control Function5Rear Panel 5Control PanelConnection to Cable Box or Satellite Box Connection5Basic Connection Antenna Cable Connection5External Device Connection Component Video Cable ConnectionVideo Cable Connection Video Connection RCA video cableInitial Setting 5Initial Setup5Main Menu 5Language Selection 5Auto Channel ScanUse CH. K/L or the Number buttons What is the minor channel?Watching TV 5Channel SelectionSAP 5Switching Each Mode5Switching Audio Mode MainProgram Guide 5Screen InformationPress Display Broadcasting InformationLetterbox 5TV Screen Display Mode5Sleep Timer To Cancel the Sleep Timer5Channel Add/Delete Optional SettingTint Sharpness 5Picture Adjustment5Closed Caption Brightness ContrastEnter To select Caption SERVICE, thenPress Enter repeatedly to change the setting To select DTVCC, then press5DTVCC Style You can adjust color temperature of the TV screen 5Back Light Setting5Color Temperature You can set the desired brightness modeCertain programming inappropriate for children 5V-chipTo select Mpaa RATING, then press Change the settingTo Set the Sub Ratings Association of AmericaEnter password again in Confirm Password space Change Password5Troubleshooting Guide TroubleshootingPhone cameras MaintenanceControl’s infrared signal With an AM radioInformation Limited Warranty