Handling of Self-Diagnostic Screen Display
Since the diagnostic results displayed on the screen are not automatically cleared, always check the
Unless the result display is cleared to “0”, the
Clearing the Result Display
To clear the result display to “0”, press buttons on the Remote Commander sequentially when the diagnostic screen is displayed, as shown below:
Channel 8
ENTER
Quitting the Self-Diagnostic Screen
To quit the entire
Self-Diagnostic Circuit
+B overcurrent (OCP) | Occurs when an overcurrent on the +B (135V) line is detected by pin 33 of IC301 (MA Board). If |
| the voltage of pin 33 of IC301 (MA Board) is less than 1V when V.SYNC is more than seven |
| verticals in a period, the unit will automatically turn off. |
| Occurs when an absence of the vertical deflection pulse is detected by pin 5 of IC001 (MA |
| Board). Power supply will shut down when waveform interval exceeds 2 seconds. |
IK | If the RGB levels* do not balance within 2 seconds after the power is turned on, this error will be |
| detected by IC301 (MA Board). TV will stay on, but there will be no picture. |
| *(Refers to the RGB levels of the AKB detection Ref pulse that detects 1K). |
— 6 —