|
|
| |
| 1 Control Switch |
| 2 Four Claws |
2 G Board
1A Board
ANODE-CAP REMOVAL
WARNING: | High voltage remains in the CRT even after the power is disconnected. To avoid electrical shock, discharge CRT before |
| attempting to remove the anode cap. Short between anode and coated earth ground strap of CRT. |
NOTE: | After removing the anode, short circuit the anode of the picture tube and the anode cap to either the metal chassis, CRT shield |
| or carbon painted on the CRT. |
REMOVAL PROCEDURES
Turn up one side of the rubber cap in | Use your thumb to pull the rubber cap |
the direction indicated by arrow . | firmly in the direction indicated by |
| arrow . |
HOW TO HANDLE AN ANODE-CAP
Do not use sharp objects which may cause damage to the sur- face of the
Do not squeeze the rubber covering too hard to avoid damag- ing the
Do not force turn the foot of the rubber cover. This may cause the
When one side of the rubber cap sepa- rates from the anode button, the anode- cap can be removed by turning the rub- ber cap and pulling it in the direction of arrow 
.
— 10 —