Sony KV-27V40 service manual Picture Tube Removal

KV-27V40 / 27V45 / 27V65 / 29VL40 / 29VL65A / 29VL65C / 29VL85 / 29VL95

2-5. PICTURE TUBE REMOVAL

WARNING: BEFORE REMOVING ANODE CAP

H.V. remains in the CRT even after the power is disconnected. Discharge CRT before attempting to remove the anode cap to avoid electrical shock. Short between anode and CRT coating earth ground strap.

Coating earth ground strap

	Two DGC holders (M)
	E board
	A board
Degaussing coil
CV board	K board
	(KV-27V65/29VL95/29VL65A/29VL65C ONLY)
Deflection yoke	P board (KV-27V45/29VL85/27V65/29VL95/
	29VL65A/29VL65C ONLY)

Four screws (Tapping screw 7)

Anode cap

HV board

Tension spring (B)

Picture tube

Cushion

ANODE-CAP REMOVAL

NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after removing the anode.

REMOVAL PROCEDURES

Turn up one side of the rubber cap in	Use your thumb to pull the rubber cap
the direction indicated by arrow .	firmly in the direction indicated by
	arrow .

HOW TO HANDLE AN ANODE-CAP

Do not use sharp objects which may cause damage to the sur- face of the anode-cap.

Do not squeeze the rubber covering too hard to avoid damag- ing the anode-cap. A material fitting called a shatter-hook ter- minal is built into the rubber.

Do not force turn the foot of the rubber cover. This may cause the shatter-hook terminal to protrude and damage the rubber.

When one side of the rubber cap sepa- rates from the anode button, the anode- cap can be removed by turning the rub- ber cap and pulling it in the direction of arrow .

— 23 —