Operation
Operation
Plasma Display status indicators
The table below shows the operational status of the Plasma Display. You can check the current status of the Plasma Display with the indicators on the Plasma Display.
POWER ON STANDBY
STANDBY indicator
POWER ON indicator
MAIN POWER switch
07
English
|
|
|
| Indicator Status |
|
| Plasma Display Status |
POWER ON | STANDBY | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| The power cord of the Plasma Display has been disconnected. Or, the power cord of |
|
|
|
|
|
| ||
|
|
|
|
|
|
| the Plasma Display has been connected but the MAIN POWER switch of the |
|
|
|
|
|
|
| Plasma Display is off. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Power to the Plasma Display is on. |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| The Plasma Display is in the standby mode. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| With the Power Management function (page 29) set to “On”, no signal was |
Flashing |
|
| detected, with the result that the unit switched to the standby mode. The unit will | ||||
|
| turn back ON, under one of the following conditions: | |||||
•The main unit’s INPUT is pressed;
•One of the remote control unit’s INPUT 1 to INPUT 6 is pressed;
•An input signal is detected once again.
(Repeatedly lights 1 second, then goes out 1 second)
|
| The unit’s protection circuit may have operated. |
| Flashing | Press the MAIN POWER switch to turn the unit off, then wait one minute before |
| turning the unit on again. | |
(The indicator will light 1 second, then go out for 1 second; |
| |
after several repeats, the indicator will go out for 2.5 |
| |
seconds, and then the cycle will repeat.) |
| |
|
| |
Flashing |
|
|
(The indicator will light 1 second, then go out for 1 second; |
| |
after several repeats, the indicator will go out for 2.5 |
| |
seconds, and then the cycle will repeat.) |
| |
|
|
|
|
| Power to the Plasma Display is off. Or the power cord of the Plasma Display has |
|
| been disconnected. |
|
|
|
For other than the above, see Troubleshooting on page 38.
Changing the volume and sound |
|
|
|
|
| SPLIT | |
|
|
|
|
|
| ||
|
|
|
|
|
| SUB | |
Using VOLUME +/– |
|
|
|
|
| INPUT | |
VOLUME | MUTING | ||||||
| |||||||
• To increase the volume, press VOLUME +.
• To decrease the volume, press VOLUME
Using MUTING on the remote control unit
MUTING mutes the current sound output.
1Press MUTING.
• MUTING appears on the screen.
2Press MUTING again to cancel the mute mode.
• Pressing VOLUME + also cancels the mute mode.
Volume adjustment
Muting
21
En