Installation
Receiver Location
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the screen. Use of some types of fluorescent lighting can reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or moisture.
Optional External Equipment
The Video/Audio connection between components can be made with shielded video and audio cables. For best performance, Antenna cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic supply store. Before you purchase any cables, be sure you know what type of output and input connectors your various components require. Also determine the length of cable you’ll need.
For optimum quality picture
When the LCD is exposed to light from outdoors or lighting fixtures,
How to use the LCD stand
Adjust the stand to your desired angle.
•TC-14LA2
The stand angle can be adjusted between 5° forward to 15° back, and rotated 30° to the right/left.
15 5
Front 
30 | 30 |
Front
•
The stand angle is fixed 14° back.
Front
Remote control battery installation
Requires two AA batteries.
1. Open the battery cover.
2.Install the batteries and replace the cover. Note the correct polarity (+ and
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
1.Always use new batteries when replacing the old set.
2.Do not attempt to charge,
3.Battery replacement is necessary when remote control acts sporadically or fails to operate this unit.
Notes:
•Do not drop, apply shock to or step on the remote control.
•Do not spill water on the remote control.
•Do not place objects between the remote control and remote control receiver.
•Do not use remote controls for other equipment at the same time.
•If the TV does not operate even when using the remote control from a close range, it is time to replace the batteries.
Refer to the label on back of the remote control for directions on replacing batteries.
6