Getting Started
Turn on the television
Push the Power Switch to turn the television ON.
Panasonic
Notes:
1.The TV takes approximately 10 seconds to turn ON. Like your computer, it has to run a number of diagnostic and software checks before it can display any broadcast channels.
2.The indicator will be red when the television is in Standby, green when the TV is operating and off when the TV is unplugged.
3.The indicator will flash when a valid code is received from the remote control when a button is pressed.
4.If the television is not going to be used for an extended period, remove the power plug from the wall outlet.
Front Panel Controls
Push the Power Switch to turn the television ON. Unless your dealer has already programmed your television then Auto Setup will begin Please refer to page 11.
Open the front panel door to gain access to the Television Controls.
Lift the door at the symbol on the bottom right hand corner.
P an aso ni
TV / AV | This button is used to select the input to be displayed on the screen. Pressing the button shows |
| in turn: DVB, Analogue, AV1, AV2, AV3, AV4, HDMI, PC and back to DVB. |
MENU | This button displays the main menu. From this menu you can select the Picture, Sound and |
| Setup menus. See pages12, 13 and 14. |
< VOLUME > | These buttons are used to turn audio volume lower or higher. |
| If user menu is displayed these buttons are used to access or adjust user menu options. |
\/ CHANNEL /\ | These buttons are used to select the next lower / higher programme number. |
| If user menu is displayed these buttons are used to move up or down to select user menu |
| options. |
Notes:
1.When the television is in
2.This television is designed for the Australian Standard Mains Voltage of 240V 50Hz.
9