Panasonic TQBC2372-1 manual Adjusting POS. /SIZE, Clock Phase, Pixel Mode 2k1k

Adjusting POS. /SIZE

● DOT CLOCK (During “COMPONENT”, “RGB” and “PC” input signal)

Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, adjust so that any such noise is minimized.

●CLOCK PHASE

●1:1 PIXEL MODE

(During “COMPONENT”, “RGB” and “PC” input signal)

Eliminate the flickering and distortion.

Adjusts the display size when 1125i, 1125p or 1250i signal is input.

Notes:

•Select ON when you would like to replay 1920 × 1080 input signal.

•Applicable input signal;

1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p, 1250 (1080) / 50i

•Select OFF when flickering is shown around the image.

•H-SIZE, V-SIZE and DOT CLOCK cannot be adjusted when ON is selected.

●1:1 PIXEL MODE (2k1k)

(For 2k1k signals)

OFFON

When the input signal is a 2k1k signal (2048×1080 / 24p, 2048×1080 / 24sF), the display size is adjusted as follows.

OFFON (LEFT)ON (CENTER)ON (RIGHT)

Note:

2k1k signals can only be received when the Dual Link HD-SDI Terminal Board (TY-FB11DHD) is installed.

● DISPLAY SIZE Adjusts the image display size on screen.

OFF: Sets the normal image display size on screen.

ON: Sets the image display size approximately 95 % of the normal image display.

OFF ON

Notes:

•“DISPLAY SIZE” can be modified when “Studio mode” in the OPTIONS menu is “On”. When “Studio mode” is “Off”, this setting is “OFF” and cannot be changed. (see page 42)

•This setting is valid only when the input signals are as follows;

525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p, 1125/24p, 1125/30p, 1125/60p, 1125/50p, 1250/50i (Component Video, RGB, DVI, SDI, HDMI)

•When “DISPLAY SIZE” is set to “ON”, “H-POS” and “V-POS” in “POS. /SIZE” can be adjusted.

•Refer to each board’s operating instruction for DVI, SDI, HDMI’s corresponding signals.

Helpful Hint ( NORMALIZE

Normalization)

While the POS. /SIZE display is active, if the OK button is pressed during “NORMALIZE”, then all adjustment values are returned to the factory settings.

32