Messages
The following messages or service numbers appear on the television or unit’s display when something unusual is detected during startup and use.
On the television
Cannot play.
¾You inserted an incompatible disc (Discs recorded in PAL video, etc.).
Cannot display on this unit.
¾You tried to play a
¾Confirm “SD” on the unit’s display is not displayed and
No disc is inserted.
¾The disc may be upside down.
$This operation is not available.
¾Some operations are unsupported by the unit. For example;
–
IP address is not set.
¾The “IP Address” in “IP Address/DNS Settings” is
The current settings only offer minimal wireless access point security and low performance. It is recommended to change it for better security.
¾Authentication type for the Wireless LAN is set to “Open system”, or the encryption type is set to “No encryption”. It is recommended to encrypt for safety reasons. For details, refer to the instructions of the Wireless router being used. Encryption is required when playing back video, etc., from DLNA compatible devices.
On the unit’s display
F99
¾The unit fails to operate properly. Press [POWER Í/I] on the main unit for 3 seconds to switch the unit to standby, then switch back on.
HDMI ONLY
¾Some
NET
¾While connecting to a network.
No PLAY
¾There is a viewing restriction on a
No READ
¾The media is dirty or badly scratched. The unit cannot play.
PLEASE WAIT
¾The unit is carrying out an internal process. This is not a malfunction. You cannot operate the unit while “PLEASE WAIT” is displayed.
REMOVE
¾The USB device is drawing too much power. Remove the USB device.
SET
(“ ” stands for a number.)
¾The remote control and main unit are using different codes. Change the code on the remote control.
Press and hold [OK] and the indicated number button at the same time for more than
5 seconds.
U59
¾The unit is hot.
The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears.
Select a position with good ventilation when installing the unit. Do not block the ventilation hole on the side of the unit.
U72
U73
¾The HDMI connection is not working properly.
–Turn the unit and TV off.
–Disconnect the HDMI cable between the player and the TV.
H or F
(“ ” stands for a number.) ¾ There is something unusual.
¾ Check the unit using the troubleshooting guide. If the service number does not disappear, do the following.
1 Disconnect the plug from the AC outlet, wait a few seconds, then reconnect it.
2Press [POWER Í/I] to turn the power on.
If the service number does not disappear despite doing the above, request service from the dealer. Inform the dealer of the service number when requesting service.
START
¾The system is being restarted during the firmware update. Please do not turn off the unit.
UPD/
(“ ” stands for a number.)
¾ The firmware is being updated. Please do not turn off the unit.
FINISH | Reference | |
¾ The firmware update is complete. | ||
| ||
|
|
VQT3B58 37