Connections
PC Input Terminals connection
COMPUTER
Conversion adapter (if necessary)
(Example:
AUDIO
PC IN
Mini
RGB
PC cable
Audio | Stereo plug |
Connect a cable which matches
the audio output terminal on the computer.
Notes:
•Due to space limitations, occasionally you may have trouble connecting Mini
•Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
•The display resolution is a maximum of 768 × 720 dots
•The PC input terminals are
•Some PC models cannot be connected to the set.
•There is no need to use an adapter for computers with DOS/V compatible Mini
•The computer shown in the illustration is for example purposes only.
•Additional equipment and cables shown are not supplied with this set.
•Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency range.
•Component Input is possible with the pin 1, 2, 3 of the
•Change the
Signal Names for Mini D-sub 15P Connector
11 | 12 | 13 |
| 14 | 15 |
6 | 7 | 8 | 9 | 10 |
1 2 3 4 5
5 |
| 4 | 3 | 2 |
| 1 |
10 | 9 |
| 8 | 7 | 6 | |
15 | 14 | 13 | 12 |
| 11 |
Pin No. | Signal Name | Pin No. | Signal Name | Pin No. | Signal Name |
1 | R (PR/CR) | 6 | GND (Ground) | 11 | NC (not connected) |
2 | G (Y) | 7 | GND (Ground) | 12 | SDA |
3 | B (PB/CB) | 8 | GND (Ground) | 13 | HD/SYNC |
4 | NC (not connected) | 9 | NC (not connected) | 14 | VD |
5 | GND (Ground) | 10 | GND (Ground) | 15 | SCL |
Pin Layout for PC Input Terminal
10