Panasonic TH-PH10 Color System / Panasonic Auto, Pulldown / Video NR, SET UP for Input Signals

SET UP

SET UP for Input Signals

COLOR SYSTEM / Panasonic AUTO

Select SIGNAL from the “SET UP” menu during VIDEO (S VIDEO) input signal mode.(“SIGNAL [VIDEO]” menu is displayed.)

Press to select the “COLOR SYSTEM” or “Panasonic

AUTO”.

Press to select each function.

If the image becomes unstable:

With the system set on Auto, under conditions of low level or noisy input signals the image may in rare cases become unstable. Should this occur, set the system to match the format of the input signal.

SET UP 1/2

SIGNAL

COMPONENT/RGB-IN SELECT

RGB

INPUT LABEL			PC
POWER SAVE			OFF
STANDBY SAVE			OFF
POWER MANAGEMENT			OFF
AUTO POWER OFF			OFF
OSD LANGUAGE	ENGLISH (US)
Press ACTION (			) button
SIGNAL			[ VIDEO ]
3D Y/C FILTER (NTSC)			ON
COLOR SYSTEM			AUTO
3 : 2 PULLDOWN			OFF
Panasonic AUTO (4 : 3)		NORMAL
VIDEO NR			OFF

Mode			Function
COLOR SYSTEM Set the color system to match the input signal. When selecting “AUTO”, the color system is automatically
	selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on
	the attached terminal board. To display M.NTSC signal, select “M.NTSC” in COLOR SYSTEM.
	AUTO	PAL	SECAM	M.NTSC	NTSC
Panasonic AUTO	Set to “NORMAL” to view 4:3 images in an unchanged format when Panasonic AUTO is
(4 : 3 )	selected. If you would like to view 4:3 images in Just format, set to “JUST”.

Note:

Panasonic AUTO does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.

3:2 PULLDOWN / VIDEO NR

3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as movie

pictures, which are recorded at 24 frames per second.1/2 If the picture is not stable, turn the setting to OFF.

Notes:
	SIGNAL
When ON, this setting only affects the following signal input:	COMPONENT/RGB-IN SELECT
				RGB
• NTSC / PAL signal input during “VIDEO (S VIDEO)” input signal.
	INPUT LABEL			PC
• 525i(480i), 625i(575i), 1125(1080)/60i signal input during “COMPONENT” input signal.
	POWER SAVE			OFF
	STANDBY SAVE			OFF
VIDEO NR: Automatically reduces unwanted picture noise.	POWER MANAGEMENT			OFF
	AUTO POWER OFF			OFF
Note:	OSD LANGUAGE	ENGLISH (US)
VIDEO NR cannot be adjusted while a PC signal is being applied.	Press ACTION (		) button

1

Press to select 3:2 PULLDOWN or VIDEO NR. Press to set ON/OFF.

SIGNAL		[ VIDEO ]
3D Y/C FILTER (NTSC)		ON
COLOR SYSTEM		AUTO
3 : 2 PULLDOWN		OFF
Panasonic AUTO (4 : 3)		NORMAL
VIDEO NR		OFF
SIGNAL	[ COMPONENT ]

SIGNAL		[ RGB ]
SYNC		AUTO
3 : 2 PULLDOWN		OFF
VIDEO NR		OFF
H-FREQ.		kHz
	33.8
V-FREQ.		Hz
	60.0
SIGNAL		[ Digital ]

2

3 : 2 PULLDOWN	OFF
VIDEO NR	OFF

Press to exit from adjust mode.

3 : 2 PULLDOWN		OFF
VIDEO NR		OFF
H-FREQ.	33.8	kHz
V-FREQ.	60.0	Hz

37