Panasonic TH-PH10 manual Options Adjustments, Off Initial VOL Sets normal volume Level

Options Adjustments

Options1/3

Weekly Command Timer

Onscreen display		On
Initial INPUT		Off
Initial VOL level	Off	0
Maximum VOL level	Off	0
INPUT lock		Off
Button lock		Off
Remocon User level		Off
Advanced PIP		Off

Item Effect Adjustments

Press button to adjust the volume when the unit is turned on.

		Off	On
Initial VOL		Off:	Sets normal volume.
level	Off On	On:	Sets your preferred volume.
		Notes:

•When “Maximum VOL level” is “On”, the volume can only be adjusted between 0 and your maximum range.

•You can hear the changed volume regardless of your volume setting before opening the options menu if you adjust the volume when “Initial VOL level” is “On” and cursor is on the menu.

			Press		button to adjust the maximum volume.
			Off		On
			Off:	Sets auto maximum volume.
Maximum VOL			On:	Sets your preferred maximum volume.
level	Off	On	Notes:
			• If the “Maximum VOL level” is set lower than the “Initial VOL level”, the “Initial VOL level” automatically
			becomes the same as the “Maximum VOL level”.
			• The volume display can go up to 63 regardless of the settings.
			• You can hear the changed volume regardless of your volume setting before opening the options menu if you
			adjust the volume when “Maximum VOL level” is “On” and cursor is on the menu.

Off PC INPUT1 INPUT2 INPUT3

Locks the input switch operation.

Notes:

•Only the adjusted signal is displayed (see page 18).

•Signal can be displayed when the Terminal board is installed.

INPUT lock • Input switch can be used when this is set to “Off”.

•In two screen display mode, if anything other than “Off” is set, the value will be fixed as the value input in the single screen display mode.

•When a dual input terminal board is attached, A or B is displayed depending on the selected input signal. (Ex. INPUT1A, INPUT1B)

•Setting of SLOT3 is not available on TH-37PH10UK.

Off MENU&ENTER On

Off: All the buttons at the bottom of the main unit can be used.

MENU & ENTER: Locks and buttons on bottom face of main unit.

					MENU	ENTER/
Button lock	On: Locks all the button on bottom face of main unit.
	Sets Button lock with the unit buttons in the following procedure.
	Off: Press		four times→Press			four times→Press		four times→Press
	MENU & ENTER: Press					INPUT	four times→Press		ENTER/
					four times→Press				four times→Press
	On: Press				ENTER/	four times→Press			INPUT	ENTER/
			four times→Press					four times→Press
						ENTER/			ENTER/
	Off	User1		User2		User3
	Off:	You can use all of the buttons on the remote control.
Remocon	User1:You can only use				,	, ,	, ,	, ,	buttons on the remote control.
User level	User2:You can only use				,	, buttons on the remote control.

User3:Locks all the buttons on remote control.

	Off:		Sets normal two screen display mode (see page 21).
	On:		Sets Advanced PIP mode (see page 22).
Advanced PIP Off On	Notes:
	• When “INPUT lock” is “On”, you cannot use all the two screen display functions.
	•	,	buttons are unavailable during Advanced PIP mode operation.

40