Panasonic 42HL57, 26HL57, 32HL57, 37HL57 Important notes about your LCD TV, Trademark Information

Page 5

Choosing a location for your LCD TV

To Display your LCD TV on the included Pedestal Stand:

Observe the following safety precautions:

1)Read and Follow the pedestal assembly instructions included with the pedestal.

CAUTION: Before beginning pedestal assembly, carefully lay the front of the LCD Panel face down on a flat, cushioned surface such as a quilt or blanket. Leave the bottom of the unit protruding over the edge of the surface and assemble pedestal as indicated below.

Note: Extreme care should always be used when attaching the pedestal stand to avoid damage to the LCD panel.

2)Place the TV on a sturdy, level surface that can support the weight of the TV.

3)Be sure to secure the TV to a wall, pillar, surface, or other

immovable structure. To secure the TV in this manner, use the included strap located at the rear of the pedestal stand. (-item 20, page 3).

To Display your LCD TV using a Wall Bracket:

If you decide to wall mount your LCD TV, always use a UL- listed wall bracket appropriate for the size and weight of the LCD TV (- page 2) :

1)CAUTION: Two people are required for installation.

2)Unplug and remove any cables and/or other component connectors from the rear of the TV.

3)Follow the instructions provided with your wall bracket. Before proceeding, make sure the appropriate bracket(s) are attached to the wall and the back of the TV as described in the instructions provided with the wall bracket.

4)After attaching the appropriate bracket(s) to the wall and the back of the TV, remove the pedestal stand from the TV as described below.

Removing the Pedestal Stand

1)Carefully lay the front of the unit face down on a flat, cushioned surface such as a quilt or blanket. Leave the stand protruding over the edge of the surface.

Note: Extreme care should always be used when removing the pedestal stand to avoid damage to the LCD panel.

2)Remove the jack pack cover on the back of the TV to expose the pedestal stand screws. The jack pack cover can be removed without tools.

3)Remove the five screws shown in the diagram below. This will allow removal of the pedestal stand.

4)Once you have removed all five screws holding the pedestal stand in place, remove the pedestal stand from the TV by sliding the pedestal stand away from the TV.

Five screws

Important notes about your LCD TV

The following symptoms are technical limitations of LCD Display technology and are not an indication of malfunction; therefore, Toshiba is not responsible for perceived issues resulting from these symptoms.

1)An afterimage (ghost) may appear on the screen if a fixed, non- moving image is displayed for a long period of time. The afterimage is not permanent and will disappear in a short period of time.

2)The LCD panel contained in this TV is manufactured using an extremely high level of precision technology; however, there may be an occasional pixel (dot of light) that does not operate properly (does not light, remains constantly lit, etc.). This is a structural property of LCD technology, is not a sign of malfunction, and is not covered under your warranty. Such pixels are not visible when the picture is viewed from a normal viewing distance.

Note: Interactive video games that involve shooting a “gun” type of joystick at an on-screen target may not work with this TV.

Trademark Information

WOW, SRS and l symbol are trademarks of SRS Labs, Inc. WOW technology is incorporated under license from SRS Labs, Inc.

HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.

5

Image 5
Contents LCD Color Television 26HL57 32HL57 37HL57 42HL57 Dear Customer Safety PrecautionsInstallation, Care, and Service Important Safety InstructionsAdditional Safety Precautions InstallationCare ServiceChoosing a location for your LCD TV Important notes about your LCD TVTrademark Information Contents Welcome to Toshiba Features of your new TVIntroduction TV front and side panel controls and connections ColorStream HD-1 and ColorStream HD-2 TV back panel connectionsFor an explanation of cable types and connections, see Overview of cable types Connecting your TVTo view the antenna or Cable signal Connecting a VCR and antenna or Cable TV no Cable boxYou will need To view the VCRTo view basic and premium Cable channels Connecting a VCR with S-video and a cable boxCoaxial cables Video cable Standard audio cablesTo view the DVD player To view antenna or Cable channelsTo view the VCR or view and record antenna channels To record a TV program while watching a DVDConnecting an audio system Connecting a camcorderTo view the camcorder video To control the audioFormat Resolution Frequency Connecting an Hdmi or DVI device to the Hdmi inputTo connect an Hdmi device, you will need To view the Hdmi device videoTo connect a PC to the Hdmi terminal on the TV Connecting a personal computer PCTo connect a PC to the PC in terminal on the TV Preparing the remote control for use Using the remote controlInstalling the remote control batteries Remote control effective rangeLearning about the remote control To use your TV remote control to operate a Using the remote control to operate your other devicesVCR, set the Mode Select Switch to VCR CH BbCable SAT VCR DVD Remote Control functional key chartProgramming the remote control to operate your other devices Satellite receiver Cable converter boxTV/VCR Combo DVD/VCR ComboHtib Icon Option Menu layout and navigationMenu Layout Navigating the menu system Selecting the menu language Setting up your TVProgramming channels automatically To select the menu languageManually adding and deleting channels in the channel memory Programming your favorite channelsTo add or delete channels in the channel memory To add and delete channels in the Favorite Channel listsLabeling channels When the sound is not audible Setting the Hdmi audio modeTo set the Hdmi audio mode To select the video input source using the program list Using the TV’s featuresSelecting the video input source to view Labeling the video input sourcesTuning your favorite channels Tuning channelsTuning to a specific channel programmed or unprogrammed Switching between two channels using Channel ReturnFull picture size for 43 480i, 480p source programs only Natural picture sizeTheaterWide 1 picture size Using the auto aspect ratio feature Adjusting the Picture PositionSignal Automatically selected when Source Auto Aspect is On Selection Pressing C Pressing cSelecting the gray level for 43 mode side panels Using the blue screen functionSelecting the picture mode Adjusting the pictureAdjusting the picture quality Mode Picture QualityUsing CableClear/DNR digital noise reduction Using the black stretch featureUsing Mpeg noise reduction Selecting the color temperature Using the closed caption modeTo select the color temperature To view captions or textClosed Caption Reception Adjustment Adjusting the audioMuting the sound Selecting stereo/SAP broadcastsUsing the SRS WOW surround sound feature Adjusting the audio qualityTo adjust the audio quality To adjust the WOW settingsUsing the StableSound feature Using the Locks menuEntering the PIN code If you cannot remember your PIN codeLocking channels Using the Video lock featureChanging your PIN code Setting the PC Audio Using the PC settings featureTo adjust the PC settings To set the PC AudioSetting the On timer Setting the sleep timerUnderstanding the last mode memory feature Understanding the auto power off featureDisplaying TV setting information on-screen using Recall To display TV setting information on-screenGeneral troubleshooting TroubleshootingClosed caption problems Remote control problemsChannel tuning problems Appendix SpecificationsPin No Signal name For Toshiba Brand Flat Panel Televisions Limited Canadian WarrantyDisclaimer and Limitation of Remedy 11, 12 IndexPage 07-04