Panasonic 32HL57 Setting up your TV, Selecting the menu language, To select the menu language

Press B or b to highlight TV/CABLE.

Chapter 5: Setting up your TV

Selecting the menu language

You can choose from three different languages (English, French and Spanish) for the on-screen display of menus and messages.

To select the menu language:

1 Press Yand open the Set Up menu.

2 Press B or b to highlight Language.

Set Up	1/2
Language	English
TV/CABLE	TV
CH Program	ENTER
Add/Erase	Add
Channel Labeling	ENTER
Video Label
MENU Back EXIT Exit

3 Press C or c to display your desired language. 4 Press Oto close the Set Up menu.

Programming channels into the TV’s channel memory

When you press <or ,on the remote control or TV control panel, your TV will stop only on the channels you program into the TV’s channel memory.

Follow the steps below to program channels into the TV’s channel memory.

Programming channels automatically

Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are programmed automatically, you can manually add or erase individual channels in the channel memory.

Note:

•If the input signal type is set to CABLE for an antenna input, the automatic channel programming process erases channels that were previously programmed into the TV’s memory.

•If the input signal type is set to TV, the automatic channel programming process does NOT erase channels that were previously programmed into the TV’s memory, but adds newly found channels to the existing set of programmed channels. To remove a channel from the memory, you must manually delete it.

•To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control.

•Programming channels for an antenna input configured for CABLE will take substantially longer than for an antenna input configured for TV. This is normal; however, once channel programming is completed, you should not have to repeat the programming process again unless your Cable TV service lineup changes significantly.

To program channels automatically:

1 Press Yand open the Set Up menu.

2

3 Press C or c to select either TV (if you use an antenna) or CABLE (if you use cable channels).

Set Up	1/2
Language	English
TV/CABLE
	CABLE
CH Program	ENTER
Add/Erase
	Add
Channel Labeling	ENTER
Video Label
MENU Back EXIT Exit

26