Panasonic AJ-D950 manual Operation, Memory stop function, Cap.Lock, Auto REW

Setup menus

USER menu

<OPERATION> (continued)

	Item		Setting
						Description
No.	Superimposed	No.		Superimposed
	display				display
108	CAP.LOCK	0000			4F	This selects the CAPSTAN LOCK mode for the 4F and 8F
		0001			8F	settings of the CF switch.
						0: 4F mode
						1: 8F mode
						<Note>
						This setup menu is not displayed in the 525 mode.
109	AUTO REW	0000			OFF	This selects whether to rewind the tape automatically to the
		0001			ON	tape start when the tape end is detected.
						0: The tape stops at the tape end.
						1: The tape is rewound to the tape start.
110	MEMORY	0000			OFF	This selects whether the VTR is to stop automatically when
	STOP	0001			ON	the counter value reaches “0” during a fast forwarding or
						rewinding operation in the CTL mode.
						0: The VTR does not stop.
						1: The VTR stops automatically.
						<Notes>
						1. The stop mode concerned is either the stop or the still-
						picture (SHTL STILL) mode depending on the setup menu
						No. 315 (AFTER CUE-UP) setting.
						2. When both the AUTO REW function and MEMORY function
						have been selected at the same time, the AUTO REW
						function takes precedence.

The underline on the setting item denotes the initial setting.

Memory stop function

The MEMORY STOP function does not work if it is activated within a range of 0 ±2 frames.

FWD direction

	Zero
	point
REW button	1 FF button
FF button	2 REW button

zWhen the FF button is pressed, the VTR performs the regular fast forward operation since the zero point is not located in the direction of operation.

xWhen the REW button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the preroll operation, and it automatically stops when it reaches the position where the counter reads “0.”

cWhen the REW button is pressed, the VTR performs the regular rewinding operation since the zero point is not located in the direction of operation.

vWhen the FF button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the preroll operaiton, and it automatically stops when it reaches the position where the counter reads “0.”

– 50 –