Panasonic AJ-D950 RS-232C Remote 25-pin D-SUB crossover cable supported, Preroll Command, Gnd

Connector signals

PARALLEL REMOTE (25P)

Pin No.	Signal	Pin No.	Signal	Pin No.	Signal
1	PLAY COMMAND	10	—————	19	STAND BY ON STATUS
2	STOP COMMAND	11	—————	20	PREROLL STATUS
3	FF COMMAND	12	³10V, MAX 300mA	21	SERVO LOCK STATUS
4	REW COMMAND	13	PLAY STATUS	22	—————
5	REC COMMAND	14	STOP STATUS	23	—————
6	EJECT COMMAND	15	FF STATUS	24	—————
7	STAND BY ON/OFF COMMAND	16	REW STATUS	25	GND
8	PREROLL COMMAND	17	REC STATUS
9	IN SET COMMAND	18	EJECT STATUS

<Notes>

•COMMAND pins: TTL level, active low, ³100ms edge electrical signal.

•STATUS pins: open collector, sink current 6 mA

RS-232C REMOTE (25-pin D-SUB crossover cable supported)

Pin No.	Abbreviation	Circuit	Description
1	FRAME GROUND	Protective ground	Frame ground
2	RxD	Received data	Sends data to the PC.
3	TxD	Transmitted data	Receives data from the PC.
4	CTS	Clear to send	Shorted with pin 5.
5	RTS	Request to send	Shorted with pin 4.
6	DTR	Data terminal ready	No processing
7	GND	Signal ground	Signal ground
20	DSR	Data set ready	Positive power output after communication
			enable status

ENCODER REMOTE (15P)

Pin No.	Signal	Pin No.	Signal	Pin No.	Signal
1	—————	6	SYSTEM H 0	11	RET GND
2	SET UP	7	SYS.SC COARSE (2)	12	—————
3	C LEVEL	8	–12V	13	—————
4	GND	9	HUE	14	SYS.SC FINE
5	+12V	10	VIDEO LEVEL	15	SYS.SC COARSE (1)

(Video output connector)

Analog component output: (option)

Analog composite output:

– 84 –