LOREX Technology SG17L7584 instruction manual Motion Set, Motion SET

Page 27

Motion Set

Motion Set

This submenu allows you to change the configurations for MOTION detection, using the monitors built-in Pixel Based Motion Detection.

1.MOTION - Sets the motion detection alarm mode. Navigate by pressing the K and L buttons to highlight, and press the OK button to switch between MOTION alarm modes:

•OFF - Motion Detection is disabled

•OSD (On Screen Display) - Visual alert only [MD]

•OSD + BUZZER - Both Visual and Audible alerts

2.CHANNEL - Configure the MOTION detect

settings for channel sets CH1/5, CH2/6, CH3/7 and CH4/8. Navigate by pressing the K and L buttons to highlight, and press the OK button to select the channel to change. Once a channel has been selected the SENSITIVITY and AREA can be configured.

3.SENSITIVITY - Configure the sensitivity of the MOTION detect. Navigate by pressing the K and L buttons to highlight, and press the OK button to set the SENSITIVITY mode from [00] to [05] (where 05 is the most sensitive setting). Press OK to accept the selection.

[MOTION SET]

MOTION	:	[OFF]
CHANNEL	:	[CH1/5]
SENSITIVITY	:	[02]
AREA	:	[00]
RETURN	:	[ ]
EXIT	:	[ ]

27

Image 27

Contents Color LCD Dual Quad Security Surveillance System Page Installation Important SafeguardsService Lorex Technology INC General PrecautionsObservation System Features Standard Camera FeaturesNetViewer Software Table of Contents Camera Remote ControlGetting Started Cameras with15 16 17 18 19 20 21 SG17L7584 Front Primary Function ButtonsUP / Down / Right SG17L7584 Front Primary Function Buttons Dual PIP POP Mode 10 11 12 13Listen in Audio only SG17L7584 Front Secondary Function Buttons MIC Enable TWO-WAY Audio with select Lorex camerasSlave Monitor SG17L7584 BackSG17L7584 Back Remote Control Input Cable Back Installing CamerasCamera Lens MicrophoneObservation System Connecting CamerasPower To Connect the Cameras to the Moni- torMonitor Features ThumbscrewsMonitor Tilting Point Cable Channel Main Menu Control Time / Date Set Disp MON Display the Date / Time onTIME/DATE SET Sequence SET Sequence SetPIP/POP SET PIP/POP SetTitle SET Title SetAlarm SET Alarm SetMotion SET Motion SetFull Screen System Set Loss Buzzer Sets the audible Buzzer onSystem SET System SET Monitor SET Monitor SetNetViewer Installation Requirements Network Connectivity Observation System Internet RouterNot Included Navigate to http//DDNS.strategicvista.net Setting Up Your Ddns AccountDns1.strategicvista.net Finding Your External IP Address Using the Lorex IPEdit ApplicationInternal Network Router Port ForwardingNetwork Example Internet Router ComputerTroubleshooting ProblemCheck Image on the Observation System is too dark or too bright TFT LCD Observation System Specifications Appendix #1Camera Specifications Appendix #2 DVR Note VCR NoteObservation System Single Channel DVR or VCR Connecting to a Multi-Channel DVR Appendix #4 RCA to BNC AdaptorDVR Unit Connecting a Slave Monitor Appendix #5 Sensor Connecting Motion / Alarm Device Appendix #61/4 CCD Cameras Included Full Connectivity Diagram Appendix #7Cameras Optional AccessoriesCable DVR Unit CameraOptional Accessories It’s all on the web