LOREX Technology SG17L7584 instruction manual Connecting Motion / Alarm Device Appendix #6, Sensor

Page 45

Connecting Motion / Alarm Device - Appendix #6

Connecting Motion / Alarm Device - Appendix #6

Motion detection and Alarm controls are enabled through the Menu system on the Observation System. Additional motion sensor devices can be connected to the system (Motion Sensors, Door/Window Sensors).

A motion detection or sensor unit can	OBSERVATION SYSTEM
be used to send a signal to the
Observation System to begin camera
viewing on the matching Video
Channel (when enabled in the
MENU/ALARM SET MODE)
• Example: A Window sensor unit
has been installed on Alarm
Block port #4. When this sensor
is activated, the camera on DIN
or BNC VIDEO port #4 will
become active (if enabled in the
MENU on the Observation
System)
For the corresponding Menu Pro-
gramming, refer to Page 26.

Installing a Sensor

1.Connect the GROUND Cable to the GND port on the Alarm Block on the Observation System

21

2.Connect the SIGNAL Cable to a numbered port (1-8)

To start ALARM RECORDING on a DVR unit, refer to the manual for your specific DVR product.

SENSOR

(Not Included)

45

Image 45

Contents Color LCD Dual Quad Security Surveillance System Page Installation Important SafeguardsService Lorex Technology INC General PrecautionsObservation System Features Standard Camera FeaturesNetViewer Software Table of Contents Getting Started Remote ControlCameras with Camera15 16 17 18 19 20 21 SG17L7584 Front Primary Function ButtonsUP / Down / Right SG17L7584 Front Primary Function Buttons Dual PIP POP Mode 10 11 12 13Listen in Audio only SG17L7584 Front Secondary Function Buttons MIC Enable TWO-WAY Audio with select Lorex camerasSlave Monitor SG17L7584 BackSG17L7584 Back Remote Control Camera Lens Installing CamerasMicrophone Input Cable BackPower Connecting CamerasTo Connect the Cameras to the Moni- tor Observation SystemMonitor Features ThumbscrewsMonitor Tilting Point Cable Channel Main Menu Control Time / Date Set Disp MON Display the Date / Time onTIME/DATE SET Sequence SET Sequence SetPIP/POP SET PIP/POP SetTitle SET Title SetAlarm SET Alarm SetMotion SET Motion SetFull Screen System Set Loss Buzzer Sets the audible Buzzer onSystem SET System SET Monitor SET Monitor SetNetViewer Installation Requirements Network Connectivity Observation System Internet RouterNot Included Navigate to http//DDNS.strategicvista.net Setting Up Your Ddns AccountDns1.strategicvista.net Finding Your External IP Address Using the Lorex IPEdit ApplicationNetwork Example Router Port ForwardingInternet Router Computer Internal NetworkTroubleshooting ProblemCheck Image on the Observation System is too dark or too bright TFT LCD Observation System Specifications Appendix #1Camera Specifications Appendix #2 DVR Note VCR NoteObservation System Single Channel DVR or VCR Connecting to a Multi-Channel DVR Appendix #4 RCA to BNC AdaptorDVR Unit Connecting a Slave Monitor Appendix #5 Sensor Connecting Motion / Alarm Device Appendix #61/4 CCD Cameras Included Full Connectivity Diagram Appendix #7Cable DVR Unit Optional AccessoriesCamera CamerasOptional Accessories It’s all on the web