5.First press the button on the URC that is to be taught. In the LCD display q "LEARNING" appears. The URC now waits for the infrared signal from the original remote control.
Note:
Should the notice not change to "LEARNING" you have selected a button for which no button code can be taught.
6.Point the infrared sensors 1( of both remote controls towards each other.
7.Now hold down the desired button of the original remote control until "SUCCESS" or "LEARN ERROR" appears in the display q of the URC.
8.If in the LCD display q "SUCCESS" appears (process successful), you can teach further buttons begining with step 5. If "LEARN ERROR" appears (process unsuccessful) repeat the process in any case from step 5.
9.To stop the learn process press, during the notice "LEARN SET", the S button then press repeatedly the EXIT button y until the standard display appears in the LCD display q. During the notice "LEARN KEY" and/or "LEARNING" sim- ply allow 25 seconds to pass without any operation then the device will end the menu.
Delete all of a device's programmed buttons
1.Press the device button e for the device that you want to delete all taught button codes.
2.Hold down the S button r for a little longer than 3 sec- onds. The notice "CODE SETUP" appears.
3.With the or button t select the menu "LEARN SETUP" and then press the OK button k. In the LCD display q "LEARN SET" appears.
4.With the or button t select "LEARN CLEAR"
(taught delete) and confirm with the OK button k. In the LCD display q "CONFIRM CLEAR" (confirm delete) appears.
5.Confirm with the OK button k. In the LCD display q
"SUCCESS" appears. All programmed buttons for the se- lected device are deleted. Finally the menu will automati- cally end.
Macro Setup
With the MACRO function up to 16 button commands can be carried out with the press of a single button, that is to say, several previously saved control commands can be deleted with one MACRO button. There are 4 Macro memory slots available for you.
- 17 -