Timer Setup
The URC offers 2 timer modes, sleep timer and event timer.
Sleep timer
1.Press the device button e for the device that is to be con- trolled (i.e. VCR).
2.Hold down the S button r for a little longer than 3 sec- onds. The notice "CODE SETUP" appears.
3.Press the or button t until "TIMER SETUP" is shown. Press the OK button k "TIMER SLEEP" appears in the LCD display q. Confirm the selection of this function with the OK button k.
4.Now, below to the right in the LCD display q blinks the minutes for the remaining time of the selected device. Set with the or button t the desired value from 1 to 99 minutes. Press the OK button k to confirm.
5.Position the remote control in such a way that your infra- red signal can reach the device to be switched off. After expiration of the set time the remote control will switch the device off.
6.To check if the SLEEP timer is activated press the S button r. Then below to the left in the LCD display q "SL" will be shown.
Event timer
The remote control has 4 event timers available via which you are allowed to send out specific series of button combi- nations at designated times.
1.Hold down the S button r for a little longer than 3 sec- onds. The notice "CODE SETUP" appears.
2.With the or button t select "TIMER SETUP" and confirm with the OK button k. "TIMER SLEEP" appears in the LCD display q. With the or button t select the desired memory slot "TIMER SETUP 1" to "TIMER
SETUP 4" and confirm with the OK button k.
3.Now the hour of the time of day, to which the desired button combinations are to be carried out, blinks. Set with the or button t the desired hour and press for con- firmation the OK button k.
4.Now the minutes of the time of day, to which the desired button combinations are to be carried out, blinks. Set with the or button t the desired minutes and press for confirmation the OK button k.
5.In the LCD display q you will see "TIMER X KEY" (X stands for the desired timer). Now press the desired device button e followed by the desired sequence of the button commands.
6.Press the S button r to save your entry and to return to the timer menu.
7.Procede in a similar manner in order to, if required, programme the other timer memory slots also.
- 15 -