Kenwood DVR-6100K instruction manual Do not plug in the power lead until, Tions are completed

Make connections as shown below.	Do not plug in the power lead until	all connec-
When connecting the related system components, refer also
	tions are completed.
to the instruction manuals of the related components.

Caution

Be sure to adhere followings. Or proper ventilation WI/ be blocked causrng damage or fire hazard.

. Do not place any objects imparrrng heat radration onto the top of unt.

lLeave a space around the unrt (from the largest outside dimensron rncludrng pro-

lection) equal or greater than, shown below		Back panel 10 cm
Top panel : 50 cm	Side panel : 10 cm

Malfunction of microcomputer

If operation IS not possible or erroneous drsplay appears even though all connec- tions have been made properly, reset the mrcrocomputer referrrng to “In case of

drfficulty”-I&

d tube I

Excessive insertion of the cable can cause defective contact.

I ’ I I

The figure shows an example for the speakers for DVR-605.

Center speaker

Surround speaker

R

Front speaker

L

Connect the speaker cable terminals to the terminals with the same color at the speaker terminal panel on the main unit. Connect matching the color of the speaker terminal (+ side) and the color of the speaker cable tube.

Speaker	Colorofthespeakerterminal
	panelon the main unit
Front right	Red
Center	Green
Front left	White
Surround right	Gray
Subwoofer	Purple
Surround left	Blue
Surround
speaker
L

Subwoofer

Speakers for DVR-6100/6100K

The power in this equipment will not be completely cut off from the AC wall outlet when the main switch is