Remote control | Power sources |
BATTERY INSTALLATION
Open the battery compartment cover in the direction of the arrow.
Install two "AAA" batteries, paying attention to the polarity diagram in the battery compartment.
Replace the compartment cover.
OPERATION
•Aim the remote control at the remote sensor and press control buttons to operate.
•Operate the remote control within 30° angle on either side of the remote sensor, up to a dis- tance of Approx. 5 meters.
Approx. 5 meters
(15 FEET)
NOTES:
•Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.
•The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote sensor may shorten operating distance.
•Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batter- ies properly.
•Do not mix old and new batteries.
•Remove batteries if the remote control will not be operated for an extended period of time.
TO USE AC POWER
Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a standard 120V 60Hz polarized AC outlet.
NOTES:
•Never connect the AC line cord plug to anything other than the specified voltage (120V 60Hz). Use the at- tached power cord only.
•If the polarized AC cord does not fit into a nonpolarized AC outlet, do not attempt to file or cut the blade. It is the user's responsibility to have an electrician replace the obsolete outlet.
•If you cause a static discharge when touching the unit, and the unit fails to function, simply unplug the unit from the AC outlet, wait a few minutes, and plug it back in. The unit should return to
normal operation.
AC Outlet
Wider Hole
and Blade
Polarized AC Cord Plug
(One blade is wider than the other)
TO USE DC POWER
By using the DC car cord supplied with the TV/DVD, you can operate this TV/DVD from a cigarette lighter socket in any car that utilizes a negative ground system.
The fused 12V DC car cord has been designed to power the set from the external DC power (12 volt negative ground) through the TV/DVD DC input jack.
Connect the smaller plug on the end of the cord to the DC input jack on the rear of the TV/DVD, then insert the other end of the car cord into the cigarette lighter socket of your car. Make sure that the cord makes a firm connection. It may be necessary to try several insertions, rotating the plug for proper electrical connection.
TV/DVD | CAR |
To Cigarette
Lighter Socket
To DC Input Jack
Car Cord (supplied)
12