Emerson LD200EM8 owner manual Introduction, Important note is located on the rear of the cabinet

Page 2

INTRODUCTION

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT.

THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.

The important note is located on the rear of the cabinet.

Important Safeguards

1.READ INSTRUCTIONS - All the safety and operating instructions should be read before the appliance is operated.

2.RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for future reference.

3.HEED WARNINGS - All warnings on the appliance and in the operating instructions should be adhered to.

4.FOLLOW INSTRUCTIONS - All operating and use instructions should be followed.

5.CLEANING - Unplug TV from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

EXCEPTION: A product that is meant for uninterrupted service and, that for some specific reason, such as the possibility of the loss of an authorization code for a CATV converter, is not intended to be unplugged by the user for cleaning or any other purpose, may exclude the reference to unplugging the appliance in the cleaning description otherwise required in item 5.

6.ATTACHMENTS - Do not use attachments not recommended by the TV manufacturer as they may cause hazards.

7.WATER AND MOISTURE - Do not use this TV near water, for example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, and the like.

8.ACCESSORIES - Do not place this TV on an unstable cart, stand, tripod, bracket, or table. The TV may fall, causing serious injury to someone, and serious damage to the appliance. Use only with a cart, stand, tripod, bracket, or table recommended by the

manufacturer, or sold with the TV.

Any mounting of the appliance should follow the manufacturer’s instructions and should

use a mounting accessory recommended by the manufacturer. An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn.

AMEUBLES - Cet appareil ne doit être placé que sur un meuble (avec ou sans roulettes) recommandé par le fabricant. Si vous l’

installez sur un meuble à roulettes, déplacez les deux ensembles avec précaution. Un arrêt brusque, l’utilisation d’une force excessive

et des surfaces irrégulières risquent de déstabiliser l’ensemble et de le renverser.

9.VENTILATION - Slots and openings in the cabinet and the back or bottom are provided for ventilation and to ensure reliable operation of the TV and to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the TV on a bed, sofa, rug, or other similar surface. This TV should never be placed near or over a radiator or heat register. This TV should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions have been adhered to.

10.POWER SOURCES - This TV should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your appliance dealer or local power company. For TVs intended to operate from battery power, or other sources, refer to the operating instructions.

11.GROUNDING OR POLARIZATION - This TV is equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

12.POWER-CORD PROTECTION - Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

13.OUTDOOR ANTENNA GROUNDING - If an outside antenna or cable system is connected to the TV, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA No. 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. (Fig. A)

FIGURE A

EXAMPLE OF ANTENNA GROUNDING AS PER

NATIONAL ELECTRICAL CODE

ANTENNA

LEAD IN WIRE

GROUND

CLAMP

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

ELEC TRIC

SER VICE

EQUIPMENT

GROUNDING CONDUCTORS (NEC SECTION 810-21)

 

GROUND CLAMPS

NEC - NATIONAL ELECTRICAL CODE

POWER SERVICE GROUNDING

S 2 8 9 8 A

ELECTRODE SYSTEM

(NEC ART 250, PART H)

14.LIGHTNING - For added protection for this TV receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the TV due to lightning and power-line surges.

15.POWER LINES - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light of power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

16.OVERLOADING - Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

2

EN

Page 1 Page 3
Image 2
Page 1 Page 3
Contents LD200EM8 Introduction Important note is located on the rear of the cabinetRADIO-TV Interference PrecautionsLaser Safety Important Copyright Information5Tilt Stand 5Supplied Accessories5Symbols Used in this Manual Repeat A-B Playback ContentsGeneral Specifications Features DTV/TV/CATV5Remote Control Function REV E button p295Control Panel 5Rear Panel Antenna Cable Connection Connection5Basic Connection Connection to Cable Box or Satellite BoxVideo Cable Connection 5External Device ConnectionComponent Video Cable Connection Video Connection Digital Audio Output ConnectionMake sure if the unit is connected to antenna or cable Initial Setting5Initial Setup Scanning and memorizing the channels automatically start5Main Menu 5Auto Channel ScanEnglish Español Français Press Setup to exit5Language Selection 5Channel Selection 5Volume AdjustmentWatching TV Main 5Switching Each Mode5Switching Audio Mode SAPBroadcasting Information 5Screen InformationPress Display Program GuideTo Cancel the Sleep Timer 5TV Screen Display Mode5Sleep Timer Letterbox5Channel Add/Delete Optional Setting5Picture Adjustment Brightness Contrast Color Tint Sharpness5Closed Caption Press Setup to display the main menuCaption Mode CAPTION1 and TEXT1 OFF CAPTION1 CAPTION2 TEXT1 TEXT25DTV Closed Caption 5DTVCC Style5Back Light Setting Change Password 5Color TemperatureYou can adjust color temperature of the TV screen ChipTV Rating To Set the Sub RatingsEnter password again in Confirm PASSWORD. space Change PasswordUse Cursor K/L to select Change PASSWORD, then press Enter Mpaa Rating5Unplayable Media Operating DVDDVD Functions 5Playable Media Any other discs without compatibility indications5Resume Playback Playback5DVD Menu Pause5Slow Forward / Slow Reverse Step-by-step Playback5Fast Forward / Fast Reverse 5ZoomChapter / Title Search During playback, press Mode repeatedly until appears5Search Functions 5Repeat Playback Time SearchDirect Search 5Repeat A-B Playback5Random Playback Stop mode, press Mode repeatedly until Random menu appears5Programmed Playback Press Play B to start random playback5On-screen Display IntroductionAudio Language 5Special SettingsSubtitle Language Camera AnglesUse Cursor K/ L to adjust the black level Black Level SettingStereo Sound Mode Virtual SurroundMarker Setup To set a markerEnter DVD Setting5DVD Language Setting Audio *1, *2Use Cursor K/L to select CUSTOM, then press Enter 5Display SettingUse Cursor K/L to select DVD SETUP, then press Enter 5DVD Audio Setting Use Cursor K/L to select AUDIO, then press EnterParental Level 5Parental SettingUse Cursor K/L to select PARENTAL, then press Enter Use Cursor K/L to select Parental LEVEL, then press EnterUse Cursor K/L to select OTHERS, then press Enter OthersYou can change the other functions Use Cursor K/L to select INITIALIZE, then press Enter 5Reset to the Default Setting5Language Code List Use Cursor K/L to select YES, then press EnterTroubleshooting 5Troubleshooting GuideDelayed behind the dialogue Check the batteries of the remote controlRefer to IR Signal Check on Entered channel numberGlossary MaintenanceInformation Atsc5Other Specifications 5General Specifications5Electrical Specification 5Cable Channel DesignationsMemo Limited Warranty
Top Page Image Contents