Emerson LD200EM8 owner manual 5Supplied Accessories, 5Tilt Stand, 5Symbols Used in this Manual

Page 4

INTRODUCTION

LOCATION

For safe operation and satisfactory performance of the unit, keep the following in mind when selecting a place for its installation:

Shield it from direct sunlight and keep it away from sources of intense heat.

Avoid dusty or humid places.

Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventilation holes.

Install the unit in a horizontal position.

Avoid locations subject to strong vibration.

Do not place the unit near strong magnetic fields.

Avoid moving the unit to locations where temperature differences are extreme.

Be sure to unplug the AC power cord from the outlet before carrying the unit.

TO AVOID THE HAZARDS OF ELECTRICAL SHOCK AND FIRE

Do not handle the power cord with wet hands.

Do not pull on the power cord when disconnecting it from an AC outlet. Grasp it by the plug.

If, by accident, water is spilled on the unit, unplug the power cord immediately and take the unit to our authorized service center for servicing.

Do not place anything directly on top of the unit.

MOISTURE WARNING

Moisture condensation may occur inside the unit when it is moved from a cold place to a warm place, or after heating a cold room or under conditions of high humidity.

When the condensation occurs inside the unit, turn the unit on and leave it at least 2 hours to dry out.

The serial number of this product may be found on the back of the unit. No others have the same serial number as yours. You should record the number and other vital information here and retain this book as a permanent record of your purchase to aid identification in case of theft.

date of purchase

 

dealer phone No.

 

serial No.

 

dealer purchase from

 

model No.

 

dealer address

 

 

 

 

 

 

 

Note about recycling:

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

5Supplied Accessories

owner’s manual

remote control

batteries

(1EMN22105)

(NF602UD)

(AA x 2)

If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

5Tilt Stand

You can adjust the stand to change the angle of the TV (-2.5° to 10°).

-2.5°10°

5Symbols Used in this Manual

The following is the description for the symbols used in this manual.

Description refers to:

TV FUNCTIONS

DVD FUNCTIONS

TV : Analog TV operation

DTV : Digital TV operation

If neither symbol appears under the function heading, operation is applicable to both.

DVD : Playback of DVD-video

CD : Playback of audio CD

If neither symbol appears under the function heading, operation is applicable to both.

4

EN

Image 4
Contents LD200EM8 Introduction Important note is located on the rear of the cabinetPrecautions Laser SafetyRADIO-TV Interference Important Copyright Information5Symbols Used in this Manual 5Supplied Accessories5Tilt Stand General Specifications ContentsRepeat A-B Playback Features DTV/TV/CATV5Remote Control Function REV E button p295Control Panel 5Rear Panel Connection 5Basic ConnectionAntenna Cable Connection Connection to Cable Box or Satellite BoxComponent Video Cable Connection 5External Device ConnectionVideo Cable Connection Video Connection Digital Audio Output ConnectionInitial Setting 5Initial SetupMake sure if the unit is connected to antenna or cable Scanning and memorizing the channels automatically start5Main Menu 5Auto Channel Scan5Language Selection Press Setup to exitEnglish Español Français Watching TV 5Volume Adjustment5Channel Selection 5Switching Each Mode 5Switching Audio ModeMain SAP5Screen Information Press DisplayBroadcasting Information Program Guide5TV Screen Display Mode 5Sleep TimerTo Cancel the Sleep Timer LetterboxOptional Setting 5Picture Adjustment5Channel Add/Delete Brightness Contrast Color Tint SharpnessPress Setup to display the main menu Caption Mode CAPTION1 and TEXT15Closed Caption OFF CAPTION1 CAPTION2 TEXT1 TEXT25DTV Closed Caption 5DTVCC Style5Back Light Setting 5Color Temperature You can adjust color temperature of the TV screenChange Password ChipTV Rating To Set the Sub RatingsChange Password Use Cursor K/L to select Change PASSWORD, then press EnterEnter password again in Confirm PASSWORD. space Mpaa RatingOperating DVD DVD Functions 5Playable Media5Unplayable Media Any other discs without compatibility indicationsPlayback 5DVD Menu5Resume Playback PauseStep-by-step Playback 5Fast Forward / Fast Reverse5Slow Forward / Slow Reverse 5Zoom5Search Functions During playback, press Mode repeatedly until appearsChapter / Title Search Time Search Direct Search5Repeat Playback 5Repeat A-B PlaybackStop mode, press Mode repeatedly until Random menu appears 5Programmed Playback5Random Playback Press Play B to start random playback5On-screen Display Introduction5Special Settings Subtitle LanguageAudio Language Camera AnglesBlack Level Setting Stereo Sound ModeUse Cursor K/ L to adjust the black level Virtual SurroundMarker Setup To set a markerDVD Setting 5DVD Language SettingEnter Audio *1, *2Use Cursor K/L to select DVD SETUP, then press Enter 5Display SettingUse Cursor K/L to select CUSTOM, then press Enter 5DVD Audio Setting Use Cursor K/L to select AUDIO, then press Enter5Parental Setting Use Cursor K/L to select PARENTAL, then press EnterParental Level Use Cursor K/L to select Parental LEVEL, then press EnterYou can change the other functions OthersUse Cursor K/L to select OTHERS, then press Enter 5Reset to the Default Setting 5Language Code ListUse Cursor K/L to select INITIALIZE, then press Enter Use Cursor K/L to select YES, then press EnterTroubleshooting 5Troubleshooting GuideCheck the batteries of the remote control Refer to IR Signal Check onDelayed behind the dialogue Entered channel numberMaintenance InformationGlossary Atsc5General Specifications 5Electrical Specification5Other Specifications 5Cable Channel DesignationsMemo Limited Warranty