Emerson EWL20D6 owner manual Menu Language, Mpaa Rating SET UP, Change Access Code

6 Press [SETUP] to exit the menu.

SETUP

NOTE

•To change the rating, the TV must be turned to an unprotected program. If “PROTECTED PROGRAM by ...” appears on the screen, please change the channel to a station that is not protected.

B MPAA RATING SET UP

Follow steps 1 to 3 in the V-CHIP SET UP on page 15.

4 Press [K] or [L] to point to your desired item, then press [ENTER] to select “BLOCK” or “VIEW”.

G	[VIEW]
PG	[VIEW]
PG–13	[VIEW]	ENTER
B R	[BLOCK]
NC–17	[BLOCK]
X	[BLOCK]

Selection	Rating Category Explanations
G	General Audience
PG	Parental Guidance suggested
PG-13	Unsuitable for children under 13
R	Restricted; under 17 requires accompa-
	nying parent or adult guardian
NC-17	No one under 17 admitted
X	Mature audience only

•When you select a rating and set it to “BLOCK”, the higher ratings will be blocked automatically. The lower ratings will be available for viewing.

•When you set the lowest rating to “VIEW”, all other ratings will automatically be available for viewing.

5 Press [SETUP] to exit the menu.

SETUP

C CHANGE ACCESS CODE

Follow steps 1 to 3 in the V-CHIP SET UP on page 15.

4 Press the Number buttons to enter your desired access code in the “NEW CODE” space, then enter the same code in the “CONFIRM CODE” space. When completed, the menu will return to “V-CHIP SET UP”.

1	2	3	NEW CODE
			X X X X
4	5	6
7	8	9	CONFIRM CODE
			_ _ _ _

0

•Make sure you enter exactly the same new code in the “CONFIRM CODE” space as one in the “NEW CODE” space. If they are different, the “NEW CODE” space is cleared for redoing.

5 Press [SETUP] to exit the menu.

SETUP

NOTE

•Your personal access code will be erased and will return to the default (0000) when a power failure occurs or when you turn off the power using a wall switch. If you have forgotten the code, unplug the power cord for 10 seconds to restore the access code to 0000.

MENU LANGUAGE

1 Press [SETUP] then press [K] or [L] to point to “LANGUAGE”.

- TV SET UP -

CHANNEL SET UP

SETUPV-CHIP SET UP

B LANGUAGE [ENGLISH]

CAPTION [OFF]

BACK LIGHT [BRIGHT]

2 Press [ENTER] repeatedly to select “ENGLISH”, “ESPAÑOL”= Spanish or “FRANÇAIS”= French.

ENTER

3 Press [SETUP] to exit the menu.

SETUP

NOTE

•This function effects only the language on the screen menu and not the audio source.

•If for some reason the menu is in Spanish or French, press [SETUP], press [K] or [L] to point to “IDIOMA [ESPAÑOL]” or “LANGAGE [FRANÇAIS]”, then press

[ENTER] repeatedly to select desired language, then press [SETUP].

EN - 16 -