Directed Electronics 2.2 manual Replacement remotes, System maintenance, Low battery indicator

Page 11

➤Replacement remotes

Your system comes with two Responder remote controls (P/N 7153X).

If additional remotes are desired, please see your authorized dealer or visit www.directedstore.com to order.

➤System maintenance

The system requires no specific maintenance. Your One way remote is powered by small coin cell lightweight 3-volt lithium battery that will last approximately one year under normal use. The remote uses one CR2032 cell battery. When the battery begins to weaken, the operat- ing range will be reduced.

➤Low battery indicator

When the batteries are low the alarm then emits an additional chirp upon disarming of the alarm to let you know its time to change the remote battery.

Note: The Arm/Disarm chirps should be programmed ON for the alarm to emit any additional chirps during disarm. Ask your authorized dealer if you have any questions.

➤Battery Replacement

Slide the door up to expose the battery beneath the holder. Remove the expired battery. Place the new battery into the remote control. When power is returned the remote control is ready for use.

➤Two Car Operation

You can use the remote control system for two cars with full command capability for both vehicles.

© 2008 Directed Electronics. All rights reserved.

11

Image 11

Contents Model Security and Remote Start Owner’s Guide Page Contents Page Government regulations Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Important information What is includedYour warranty Battery Replacement Replacement remotesSystem maintenance Low battery indicatorTo change the car selection Way remote Feature DescriptionAUX Transmitter configurationFeature List Sensor Bypass Runtime resetValet mode AuxDefogger Timer modeCar finder Smart startWhile the system is armed Using the systemArming the system Directed Electronics. All rights reserved Modified Arming Modes While the system is armed normally Disarming the SystemSystem override Valet modeTo configure the remote control features Remote feature programmingTo program the remote user features Remote Beeps feature Panic modePoints to remember Using the remote startRemote starting your vehicle To drive your vehicle after it has been remote started Manual transmission vehiclesTo activate timer mode with an automatic transmission Timer modeTurbo timer mode Smart start To activate Smart Start modeTo activate Smart Start mode with a manual transmission Turning on the rear defogger Use one of the below methods to exit Smart Start modeValet take-over Disabling the remote start system Safety featuresStarter anti-grind circuitry Arming DiagnosticsTable of zones DisarmingSystem status chirps Nuisance prevention circuitry Interpreting zone diagnosticsDirected Electronics. All rights reserved Rapid resume logic Owner recognitionPower saver mode Programming options Siren tones and chirp volume The output of the RevengerSoft Security & convenience expansions Page Glossary of terms Page Quick reference guide Location of Valet button Directed Electronics. All rights reserved Directed Electronics. All rights reserved Limited lifetime consumer warranty Directed Electronics. All rights reserved Page Company behind this system is Directed Electronics