Directed Electronics 2.2 Using the remote start, Remote starting your vehicle, Points to remember

Page 25

Using the remote start

Read this user guide, including the Warnings section at the beginning. Ensure that the vehicle is parked in the open air and not in a garage. To use your remote start to pre-warm or pre-cool your vehicle, remember to set the climate controls to the desired settings before shutting off the engine.

Remote starting your vehicle

Before using the remote start be sure the vehicle is parked in a safe area with proper ventilation.

To remote start the vehicle:

Press the button on the remote control. The vehicle parking

light flashes

The preset remote start run time is 12 minutes. This can be changed to between 12 and 60 minutes (see your authorized dealer for program- ming changes).

Points to remember

If the hood is open or is the brake pedal is pressed, the vehicle will not start using remote start. The remote starter shuts down:

When the brake pedal is pressed

The hood is opened

If the alarm is triggered when armed.

When the Remote Start command is sent again from a remote control.

© 2008 Directed Electronics. All rights reserved.

25

Image 25
Contents Model Security and Remote Start Owner’s Guide Page Contents Page Government regulations Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Your warranty What is includedImportant information System maintenance Replacement remotesLow battery indicator Battery ReplacementTo change the car selection Way remote Feature DescriptionAUX Transmitter configurationFeature List Valet mode Runtime resetAux Sensor BypassCar finder Timer modeSmart start DefoggerArming the system Using the systemWhile the system is armed Directed Electronics. All rights reserved Modified Arming Modes While the system is armed normally Disarming the SystemSystem override Valet modeTo program the remote user features Remote feature programmingTo configure the remote control features Remote Beeps feature Panic modeRemote starting your vehicle Using the remote startPoints to remember To drive your vehicle after it has been remote started Manual transmission vehiclesTo activate timer mode with an automatic transmission Timer modeTurbo timer mode To activate Smart Start mode with a manual transmission To activate Smart Start modeSmart start Turning on the rear defogger Use one of the below methods to exit Smart Start modeValet take-over Starter anti-grind circuitry Safety featuresDisabling the remote start system Arming DiagnosticsSystem status chirps DisarmingTable of zones Nuisance prevention circuitry Interpreting zone diagnosticsDirected Electronics. All rights reserved Rapid resume logic Owner recognitionPower saver mode Programming options Siren tones and chirp volume The output of the RevengerSoft Security & convenience expansions Page Glossary of terms Page Quick reference guide Location of Valet button Directed Electronics. All rights reserved Directed Electronics. All rights reserved Limited lifetime consumer warranty Directed Electronics. All rights reserved Page Company behind this system is Directed Electronics