Directed Electronics 2.2 manual Location of Valet button

Page 46

Press four times, and then press (only after remote start is ON.)

To disable the remote start system

Move the shutdown toggle switch to the OFF position.

Location of Shutdown Toggle Switch___________________

Valet Mode

Press two times and then .

Valet take over

Before turning off the engine, press and release . within 3 sec- onds. Then wait a few seconds.

Turn the ignition key to the OFF position.

The engine will remain running until the programmed time elapses or a shut-down input is received.

Location of Valet button_________________________________

Cut along the dotted line and fold to keep in purse or wallet for a quick and easy reference.

 

 

 

46

 

© 2008 Directed Electronics. All rights reserved.

Image 46 Contents
Model Security and Remote Start Owner’s Guide Page Contents Page Government regulations Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Your warranty What is includedImportant information Low battery indicator Replacement remotesSystem maintenance Battery ReplacementTo change the car selection Feature Description Way remoteTransmitter configuration AUXFeature List Aux Runtime resetValet mode Sensor BypassSmart start Timer modeCar finder DefoggerArming the system Using the systemWhile the system is armed Directed Electronics. All rights reserved Modified Arming Modes Disarming the System While the system is armed normallyValet mode System overrideTo program the remote user features Remote feature programmingTo configure the remote control features Panic mode Remote Beeps featureRemote starting your vehicle Using the remote startPoints to remember Manual transmission vehicles To drive your vehicle after it has been remote startedTimer mode To activate timer mode with an automatic transmissionTurbo timer mode To activate Smart Start mode with a manual transmission To activate Smart Start modeSmart start Use one of the below methods to exit Smart Start mode Turning on the rear defoggerValet take-over Starter anti-grind circuitry Safety featuresDisabling the remote start system Diagnostics ArmingSystem status chirps DisarmingTable of zones Interpreting zone diagnostics Nuisance prevention circuitryDirected Electronics. All rights reserved Owner recognition Rapid resume logicPower saver mode Programming options Siren tones and chirp volume The output of the RevengerSoft Security & convenience expansions Page Glossary of terms Page Quick reference guide Location of Valet button Directed Electronics. All rights reserved Directed Electronics. All rights reserved Limited lifetime consumer warranty Directed Electronics. All rights reserved Page Company behind this system is Directed Electronics