➤Valet take-over
The Valet take-over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on.
To perform Valet take-over:
1.Before turning off the engine, press and release 
on the trans- mitter. Then wait a few seconds.
2.Turn the ignition key to the OFF position (The engine will stay running).
3.The engine will run until the pre-programmed time elapses or a shut-down input is received.
Note: To enable Valet take-over with a manual transmission, open the door and enter into manual transmission mode, as described above. The parking lights flash five times when entering Valet take-over. Once you exit the vehicle you can lock the system and the car will remain running. If the vehicle shuts down when locking, then the unit did not enter valet take-over mode.
© 2008 Directed Electronics. All rights reserved. | 31 |
