Dolby Laboratories P/N 91659 manual Off-Line, Address

Page 12

DolbyRemote Installation and Operation

Establishing Communication

 

 

 

 

through the front panel of the encoder. The rate you select in DolbyRemote must match the rate selected in the unit.

Address

The default address setting for the DP567 and DP569 is 0x8280. If the address has been changed from the front panel of the encoder, set the remote address accordingly. If DP561 is selected as the Device Type, only the Port parameter may be set; Baud and Address are fixed at 38,400 and 9080, respectively.

2.1.3Off-Line

The DolbyRemote application may be used off line, without the presence of an encoder. This allows configurations to be preprogrammed and stored. Off-line mode is selected by checking the Off Line box when opening a unit.

Figure 2-2Device Off Line

Once the desired parameters have been set, as described above, click OK. The DolbyRemote Window is displayed. When the DolbyRemote application establishes communication with the unit, it will display the unit's current settings.

2-2

Image 12
Contents DolbyRemote Dolby Laboratories Inc Corporate HeadquartersEuropean Licensing Liaison Office Far EastTable of Contents Opening a Device Further Information List of Figures DolbyRemote Open Device WindowPage DolbyRemote Overview DolbyLoadRequirements PC System RequirementsSoftware Installation Encoder FirmwareCable Installation Microsoft DLL FilesPage Starting DolbyRemote Device TypeCommunications PortOff-Line AddressAdditional Devices 3DolbyRemote WindowRemoving Devices Saving and Restoring Configurations Exporting ConfigurationsOpen Configuration File Save Configuration FilePage Audio Service Parameters Input MetersAudio Coding Mode Data RateClock Source LFE Enable Bitstream ModeDialog Normalization Audio Bandwidth Encoder ControlPass Through BypassCoding Delay Unit NamePreprocessing Input FilteringSurround Channel Processing Dynamic Range CompressionLine Mode and RF Mode Bitstream InfoBitstream Information Input Level MeterDual Mono Audio Production InformationAudio Service Configuration Input Level, Line Mode and RF ModeDialog Normalization Mix Level, Room Type and Info ExistsInput and Output Settings InputOutput Aux DataSource Channel AssignmentMultiplex Mode Input Subcode Status BitsTest Tone Generation Audio BitReference Input Stream NumberReference Input InputPresets Reference Input Subcode Status BitsRecall Stream NumberConfigure Save Current ConfigurationTime Code Parameters NumberPreset Current Time CodeStart Time Code and Stop Time Code Values StatusSelect Stereo Music in the Preset Pending field ResumeOpening a Device DP569/DP567DP561 GeneralFurther Information Am 530 p.m., Monday Friday