Dolby Laboratories P/N 91659 manual Resume, Select Stereo Music in the Preset Pending field

Page 34

DolbyRemote Installation and Operation

Dolby Digital Parameters

 

 

 

 

For instance, you might want the Stereo Music preset to take effect at time code 00:12:22:12.

To do this, you follow the following procedure:

1.Select the Time Code tab page

2.Enter 00:12:22:12 in the Start Time Code field

3.Select Stereo Music in the Preset Pending field.

When time code 00:12:22:12 occurs, the unit will switch to the Stereo Music preset. The Preset Pending field will display None and the Current Preset field will display Stereo Music.

There are a few restrictions on the recall preset on time code feature:

•Once you have selected a start time and a preset, you can’t change the start time. If you want to change the start time, you must follow this procedure:

1.Select None in the Preset Pending field.

2.Enter the new Start Time Code value.

3.Select the correct preset in the Preset Pending field.

•Pressing any of the preset buttons, immediately invoking a preset, cancels any pending preset

•If the unit is in Time Code Control mode, start and stop encoding is determined by time code, it cannot also recall a preset based on time code. In other words, the unit can either use time code to determine when to start and stop encoding, or to determine when to recall a preset, but not both.

4.8.5Resume

This button copies the Stop Time Code value to the Start Time Code value to permit seamless encoding of two sections of continuous material.

4-18

Page 33 Page 35
Image 34
Page 33 Page 35
Contents DolbyRemote European Licensing Liaison Office Dolby Laboratories IncCorporate Headquarters Far EastTable of Contents Opening a Device Further Information List of Figures DolbyRemote Open Device WindowPage Requirements DolbyRemote OverviewDolbyLoad PC System RequirementsSoftware Installation Encoder FirmwareCable Installation Microsoft DLL FilesPage Communications Starting DolbyRemoteDevice Type PortOff-Line AddressAdditional Devices 3DolbyRemote WindowRemoving Devices Open Configuration File Saving and Restoring ConfigurationsExporting Configurations Save Configuration FilePage Audio Service Parameters Input MetersData Rate Audio Coding ModeClock Source Bitstream Mode LFE EnableDialog Normalization Pass Through Audio BandwidthEncoder Control BypassCoding Delay Unit NamePreprocessing Input FilteringSurround Channel Processing Dynamic Range CompressionBitstream Information Line Mode and RF ModeBitstream Info Input Level MeterDual Mono Audio Production InformationDialog Normalization Audio Service ConfigurationInput Level, Line Mode and RF Mode Mix Level, Room Type and Info ExistsInput and Output Settings InputSource OutputAux Data Channel AssignmentTest Tone Generation Multiplex ModeInput Subcode Status Bits Audio BitReference Input Reference InputStream Number InputRecall PresetsReference Input Subcode Status Bits Stream NumberTime Code Parameters ConfigureSave Current Configuration NumberStart Time Code and Stop Time Code Values PresetCurrent Time Code StatusSelect Stereo Music in the Preset Pending field ResumeDP561 Opening a DeviceDP569/DP567 GeneralFurther Information Am 530 p.m., Monday Friday
Top Page Image Contents