Dolby Laboratories P/N 91659 manual Software Installation, Encoder Firmware

Page 8

DolbyRemote Installation and Operation	Introduction

1.3.2Encoder Firmware

DolbyRemote requires the following encoder firmware:

DP561 Version 6.30 or later

DP567 Version 1.50 or later

DP569 Version 1.11 or later

1.4Software Installation

The DolbyRemote application is installed from two diskettes.

1.Remove any previously installed version of DolbyRemote using the Add/Remove Program command from the Control Panel.

It is strongly recommended that you exit all Windows programs before beginning the installation.

2.Insert the DolbyRemote Software Install Disk 1 into the computer.

3.Click Start and Run.

4.Browse to the DolbyRemote diskette. Select setup.exe and click OK.

5.Please read the Limitation of Liability and Welcome screens before proceeding with the installation.

6.The default installation destination for DolbyRemote is C:\Program Files\Dolby Laboratories. Click Next to accept the default or click Browse to select an alternative location.

7.Use the program folder default Dolby Laboratories or enter an alternate folder name and click Next.

8.Insert the DolbyRemote Software Install Disk 2 when prompted to do so and click OK.

9.To use the Help files in HTML format, click Yes. When the update is complete click OK. If a previous copy of DolbyRemote has been installed this prompt may not appear.

10.DolbyRemote installation is complete.

1-2

Image 8

Contents DolbyRemote Dolby Laboratories Inc Corporate HeadquartersEuropean Licensing Liaison Office Far EastTable of Contents Opening a Device Further Information List of Figures DolbyRemote Open Device WindowPage DolbyRemote Overview DolbyLoadRequirements PC System RequirementsSoftware Installation Encoder FirmwareCable Installation Microsoft DLL FilesPage Starting DolbyRemote Device TypeCommunications PortOff-Line AddressAdditional Devices 3DolbyRemote WindowRemoving Devices Saving and Restoring Configurations Exporting ConfigurationsOpen Configuration File Save Configuration FilePage Audio Service Parameters Input MetersClock Source Audio Coding ModeData Rate Dialog Normalization LFE EnableBitstream Mode Audio Bandwidth Encoder ControlPass Through BypassCoding Delay Unit NamePreprocessing Input FilteringSurround Channel Processing Dynamic Range CompressionLine Mode and RF Mode Bitstream InfoBitstream Information Input Level MeterDual Mono Audio Production InformationAudio Service Configuration Input Level, Line Mode and RF ModeDialog Normalization Mix Level, Room Type and Info ExistsInput and Output Settings InputOutput Aux DataSource Channel AssignmentMultiplex Mode Input Subcode Status BitsTest Tone Generation Audio BitReference Input Stream NumberReference Input InputPresets Reference Input Subcode Status BitsRecall Stream NumberConfigure Save Current ConfigurationTime Code Parameters NumberPreset Current Time CodeStart Time Code and Stop Time Code Values StatusSelect Stereo Music in the Preset Pending field ResumeOpening a Device DP569/DP567DP561 GeneralFurther Information Am 530 p.m., Monday Friday