Special
Expert mode
You can restrict the antenna's range or reset the antenna.
1Select the line »Installer Mode« with »V« or »Λ« and press »OK« to confirm.
– The »INSTALLER MODE« menu appears.
2 Select the preferred option with »V« or »Λ«.
–»Limit Position«: Defines the range in which the antenna may move. Use »<« to set the western limit, use »>« to set the eastern limit.
–»Move Motor«: Aligns the antenna with the selected satellite. Use »<« to align the antenna to »west«, use »>« to align the antenna to »east«.
–»Go To Stored Position«: Press »OK« to save the current antenna alignment.
–»Store Stored Position«: Aligns the antenna with the reference point of the positioner.
–»Reset DiSEqC 1.2 Limit«: Resets the limit position of the antenna.
Searching for television channels from the cable provider automatically
1Open the menu with »MENU«.
2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3 Select | the line | »Source« | with | »V« |
or »Λ« and press »OK« to confirm. | »>«, | |||
Select | the option | »Cable« with | »<«, | |
»V« or »Λ« and press »OK« to confirm.
4Select the line »Automatic Channel Search« with »V« or »Λ« and press »OK« to confirm.
– The menu appears.
20.09.2010
SOURCE SETUP15:46
AUTOMATIC CHANNEL SEARCH
Connection Type | Cabel |
Country | U.K. |
Scan Type | ATV & DTV |
Cable Scan Type | Quick |
Frequency (MHz) | Auto |
Network ID | Auto |
Exit
Back
Start Search
5Select the line »Scan Typ« with »V« or »Λ« and set the option »DTV« with »<« or »>«.
6Select the line »Cable Scan Type« with »V« or »Λ« and set the option »Quick« or »Full« with »<« or »>«.
–The search function »Quick« sets the channels according to the information provided by your cable provide in the transmission signal.
–If the option »Full« is selected, the entire fre- quency range will be scanned. The search can take a long time with this option. This option is recommended if your cable provider does not support the search type »Quick«.