Special
Searching for television channels from the cable provider manu- ally
1Open the menu with »MENU«.
2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3Select the line »Source« with »V« or »Λ« and press »OK« to confirm.
Select the option »Cable« with »<«, »>«, »V« or »Λ« and press »OK« to confirm.
4Select » Digital Manual Tuning« with »V« or »Λ« and press »OK« to confirm.
– The menu appears.
5Enter the
–The search starts after confirming, the channels found are displayed in the »Re- sults« menu.
6Press »MENU« to finish the setting.
Searching for digital terrestrial TV channels automatically
1Open the menu with »MENU«.
2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »V« or »Λ« and press »OK« to confirm.
Select the option »Air« with »<«, »>«, »V« or »Λ« and press »OK« to confirm.
Caution:
7The antenna power supply (line »Active Antenna Power«) may only be switched on if the antenna is an active indoor antenna with a signal amplifier and it is not already
supplied with a voltage via a mains plug (or similar supply). Otherwise you may cause a short circuit and irreparably dam- age your antenna.
4Select the »Active Antenna Power« with »V« or »Λ«. Switch on the antenna power supply for the antenna with »<« or »>« (»On«).
5Select the line »Automatic Channel Search« with »V« or »Λ« and press »OK« to confirm.
– The menu appears.
20.09.2010
SOURCE SETUP15:46
AUTOMATIC CHANNEL SEARCH
Connection Type | Air |
Country | U.K. |
Scan Type | DTV & ATV |
Exit
Back
Start Search